Dutton-Lainson Rigid Mount Marine Jack Review Video

The Xtreme Off-Road Swing-Up Trailer Jack w/ Dual Wheels #ORJW350D does not come with the bearings installed. You can use something like a rubber mallet or a block of wood and hammer to tap them into place until they are flush.

Yes, the Extreme Off-Road Swing-Up Jack w/ Dual Wheels iItem #ORJW500D will work for your T@B 400 Tear Drop Trailer. It looks like your trailer comes with an a-frame jack. You would need to ensure you have enough space on your tongue to accommodate…

The Extreme Off-Road Swing-Up Trailer Jack w/ Dual Wheels, #ORJW350D has an overall length of 18".

From the center of the mounting bracket (Pivot point) to the bottom of the wheels of the Extreme Off-Road Swing-Up Trailer Jack w/ Dual Wheels - Sidewind - 7" Lift - 770 lbs - Zinc #ORJW350D is 9-1/2" with the jack full retracted, and is…

I contacted Stinger Trailers and was able to verify that the Bearing Kit #BK2-100 you referenced is exactly what you need to replace the bearings and seal for the hubs on your folding motorcycle trailer. The Sure-Lube system on the trailer features a…

The Pull Pin, Easy Swivel Trailer Jack with 6" Dual Wheels - Sidewind - 1,500 lbs. #DL22580 you were looking is designed to fit trailer tongues that are up to 3" wide x 5" tall, so this will be perfect for the frame of your trailer.…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The long brackets of the Removable Extreme Off-Road Swing-Up Trailer Jack #ARK57FR that mount on inside of trailer frame are little misleading since they are much taller than the bracket on the other side of the jack that it attaches to. Basically…

Upgrading wheels on a trailer is a pretty common thing to do, but you want to make sure you have the space to do so. You should have at least 3" from the top of the tire to the bottom of the fender/wheel well and then around 1.5" between…

In height or total diameter, a 185/80-13 and 175/80-13 like part #AM1ST77 only differ by about 5/8 of an inch. The 185 would have a diameter of 24.65 inches while the 175 would have a diameter of 24.02 inches. The section width, or thickness of the…

The tire and wheel combos we carry like #AM31952 are not machined balanced. You can have the tire and wheel combos balanced at a local tire shop if you wanted to. What our tire manufacturers will do is line up the light spot on the tire with the…

For saltwater boat trailer use it is recommended to go with either a galvanized steel rim or a aluminum wheel. For a galvanized option I recommend the Americana Steel Spoke Trailer Wheel part #AM20354. Both these rims have excellent corrosion…