Curt Class III Drawbar Review Video

Standard trailer jack wheels are either plastic or metal so there isn't a rubber tire available. But we do have the Trailer Valet #STC-V211 which is both a jack and a trailer mover rated up to 500 pounds tongue. You may also be able to use mount…

Best option we have is the part #e98887 for a pin lock for the Demco coupler part #DM15000-52. This has a pin diameter of 1/4 inch and a length of 2-1/2 inches so it will fit tight to your coupler and fit well still.

Using a 60/40 ratio is a great place to start when deciding where to place your axle, placing 60 percent of the weight in front of the axle. However, there are a couple other factors that come into play. I have attached a photo that outlines that…

Rock Tamers has a heat shield specifically for their mud flaps as the part #RT76FR which is the kit you'd want since this is the mud flap system you have. There's no reason the Access one you mentioned couldn't be used but the gap the…

When installing Rock Tamer Mud Flaps, there is not an exact distance that it needs to be form the exhaust. If the exhaust on your truck is routed straight back then you will want to install Exhaust Outlets #ERT200 so that the exhaust is routed…

Thanks for reaching out! The measurements you're asking for on the B&W Tow & Stow 3-Ball Mount #BWTS10047B can be found on the attached image. I'm also linking a review video for you to reference!

The angle of the arms that hold the flaps of the Rock Tamers Heavy-Duty, Adjustable Mud Flap System #ERT00108 are adjustable so that you can add distance between the tail pipe and them as needed. If you install the heat shield part #RT76FR that you…

If the exhaust pipes are straight back and very close to the Rock Tamers mud flaps part #ERT00108 I'd recommend the grilles part #ERT200 but if they are angled or there's a decent distance the shield #RT76FR is the way to go.

Thanks for reaching out! From the hitch pin hole to the back end of the height adjusting bracket on the Curt Slim Adjustable 2-Ball Channel Mount - 2" Hitch #C46KR measures about 5-3/4" and then from that same hitch pin hole to the start of…

The Draw-Tite Max-Frame Trailer Hitch Receiver #76209 is a two inch trailer hitch receiver rated for 675 lb tongue weight and up to 4500 lbs towing capacity. There is no drilling required for this hitch installation. This receiver will work…

The Curt Slim Adjustable 2-Ball Channel Mount #C46KR that you referenced has two hitch pin holes that are one inch apart so the first pin hole has a distance of 10 inches from the ball center to the hitch pin and the other is 11 inches.

The heat shield part #RT76FR that you referenced was designed to prevent the type of damage you have on your Rock Tamers mud flap so this would be best solution. Other option is to have a turn down welded to your exhaust tip so that it is directed…