Draw-Tite Ball Mount Review 2753 Video

The Draw-Tite Max-Frame Trailer Hitch Receiver #75742 referenced in your question, which is confirmed to fit your 2014 Honda CR-V, uses four M10 X 1.25 X 30 CL8.8 hex bolts. If you happen to have any trouble threading the bolts into the frame of…

The Draw-Tite Class III Max Frame Round Tube Receiver Hitch #75742 referenced in your question is confirmed to fit your 2014 Honda CR-V LX. I did take a look at the online owner's manual for your Honda CR-V and saw that the maximum trailer…

It does seem rather odd that Draw-Tite #75742 would construct the hitch with a mount to attach a trailer connector mounting bracket when the trailer connector harnesses for the vehicle are designed to be installed so that the trailer connector is…

I can definitely help you out with that. On my end, I could not find a Hopkins 7-pin SAE J1128. With that being said, the most common 7-way on your F-350's end will look like the pins on the 7- and 4-Pole Trailer Connector Socket w/…

Between the etrailer #e98855 and the Curt #C13370 Class III trailer hitches for your 2020 Honda Odyssey I do recommend the #e98855 for a couple of reasons. The etrailler #e98855 and the Curt #C13370 are essentially the same hitch except for two key…

Basically they are the same connector with just a slightly different part number. We carry the part #HM40975 and if you ordered the 40974 from someone else (not recommended haha) you'd get the same thing which just a different part number on…

Yes, a trailer that is nose up can cause big problems. A level trailer is ideal and worth working toward for safety. The good news is that you can get the trailer almost exactly level with switching ball mounts. This is where an adjustable ball…

Your best option would be to either replace your trailer jack or add a second jack that comes with a drop leg. We had a trailer here at our facility that was in a similar situation and this method worked pretty well. We kept the original sidewind…

The length of only the shank for Curt ball mount #D-28 is 10-3/4". I attached a video for you to see more.

When determining rise you don't need to factor in the height of the hitch ball unless it's a high rise ball. The rise calculation is done by taking the measurement from the top of the hitch opening down to the ground and comparing it…

A chrome finish ball #C40036 is going to look good but it will not be corrosion resistant. A ball with a machine finish like #C40087 , is going to have about the same corrosion resistance. In terms of performance they will wear at about the same…