Dutton-Lainson Roller Bunks for Boat Trailers Review Video

The Dutton-Lainson Roller Bunk Bracket, part #DL21742, fits Dutton-Lainson Roller Bunks #DL21740 and DL21741. Four are needed to mount a pair of roller bunks. My contact at Dutton-Lainson advises that u-bolts are not specifically required to…

The CE Smith Boat Trailer #CE48810 that you referenced is equipped with 4.80/4.00-8 bias ply tires that feature a maximum speed rating of 65 mph.

You can use roller bunks like the Dutton-Lainson Boat Trailer Deluxe Roller Bunk - 5' Long Sections - 12 Sets of 3 Rollers #DL21741 instead of carpeted bunks on your 2012 Deep V Tracker boat without any marks or indentations. The roller…

The Boat Trailer Roller Bunk Brackets #DL21742 do require 7/16" U-bolts such as #7163183UB. The bunk brackets are designed to be used with Roller Bunks #DL21740 or #DL21741.

The licensing and registration paperwork is included and delivered with the CE Smith Boat Trailer, part #CE48810. The fees for licensing and registration would be paid at the time it is registered and licensed. The paperwork is not filled out at…

The CE Smith Multi Sport Boat and Kayak Trailer w/ Bunks #CE48810 is capable of carrying a boat that is up to 12' long and weighing up to 800lbs. The winch tower can be moved front to rear to get your Stryker LX 360 to sit properly with the…

You want to locate the rollers on the frame of your trailer so that they overhang slightly off the back of the trailer so that the boat will contact them before any other portion of the trailer as you load it onto the trailer. I attached a picture…

The clip that goes around 3 of the leaves of the 5-Leaf Spring part #e34SR that you referenced can go either in front of the axle or behind it. Either way would be perfectly fine. I attached an FAQ on trailer suspension for you to check out as well.

The overall measurement from the top of the roller to the bottom of the U channel is 2-1/2 inches. I have provided a photo for you that shows the dimension you inquired about. I have linked you to a parts review video for the Roller Bunk #DL21741 you…

I went out to the warehouse and pulled a roller bunk bracket #DL21742 to measure the slotted hole spacing for you. The slotted holes are 1-1/4 inches apart on center. I also made a short video showing this measurement for you.

If you do not want to mount the Dutton-Lainson Boat Trailer Deluxe Roller Bunk #DL21741 to the bunk boards, there are brackets that can be used. - Boat Trailer Roller Bunk Bracket for Dutton-Lainson Roller Bunks #DL21742 (4 needed to mount a pair of…

A minimum of two bolts will need to be used to install each Dutton-Lainson Roller bunk part #DL21741. You can also use the Roller Bunk Brackets #DL21742 to install the bunks. A pair of these are required to install each bunk.