CE Smith Bolster and Swivel Bracket Assemblies Review Video

Since the picture you submitted belongs to Karavan I can't post it here on our site, but if you check out the attached picture you can see how a very similar trailer had a set of rollers like the part #CE27710 installed. For a set of swivel…

I recommend the CE Smith Bolster And Swivel Mounting Brackets, part #CE10000G-4. These are 9 inches long and have a swivel feature that enables you to tilt the bunks to the correct angle to fit the bottom of your boat. We also carry the mounting…

The Boat Trailer Roller Bunk Brackets #DL21742 do require 7/16" U-bolts such as #7163183UB. The bunk brackets are designed to be used with Roller Bunks #DL21740 or #DL21741.

You can use roller bunks like the Dutton-Lainson Boat Trailer Deluxe Roller Bunk - 5' Long Sections - 12 Sets of 3 Rollers #DL21741 instead of carpeted bunks on your 2012 Deep V Tracker boat without any marks or indentations. The roller bunks…

What I recommend is to use 2 sets of the roller bunks #DL21740. Two bunks can cover the length of one bunk but you will need to trim one to fit. One set would be needed per bunk and then trimmed to fit. One roller bunk alone is 4 feet long. Normally…

The CE Smith Roller Bunks, #CE27700, that you referenced would be a great option for your boat trailer. These roller bunks are 4 ft long and they can be mounted directly on top of your current wood bunks. You can also use the CE Smith Mounting…

Really you'd be fine going with either tire but the better of the two are definitely Radials. Radial tires have a longer life than bias tires, usually provide a smoother and quieter ride, provide better fuel economy because they have less rolling…

Yes, you could convert your Rolco trailer from the wooden bunks to roller bunks. The Boat Trailer Deluxe Roller Bunk, part #DL21741, has a universal mount system that attaches directly to either vertical or horizontal positioned bunk boards that…

I went out to the warehouse and pulled a roller bunk bracket #DL21742 to measure the slotted hole spacing for you. The slotted holes are 1-1/4 inches apart on center. I also made a short video showing this measurement for you.

The Dutton-Lainson Roller Bunk Bracket, part #DL21742, fits Dutton-Lainson Roller Bunks #DL21740 and DL21741. Four are needed to mount a pair of roller bunks. My contact at Dutton-Lainson advises that u-bolts are not specifically required to install…

I received your picture but not the spec sheet. The 10" CE Smith Deep V Keel Roller Assembly #CE10404G is a universal keel roller that helps make loading and unloading your boat much easier. The roller itself is 9-1/4" long while the…

The Dutton-Lainson Roller Bunk #DL21741 that you referenced can be installed directly on top of your existing wooden bunks. According to the installation instructions when mounting over wooden bunks a 3/8 inch diameter lag screw is required. The…