Recommended Roller Bunks For Tracker Deep V Boat

Question

Question:

can I use roller bunks on my 2012 deep v tracker that came with carpeted bunks my concern is the weight being evenly distributed or will the roller bunks leave marks or indentions

asked by: Bill W

0

Expert Reply:

You can use roller bunks like the Dutton-Lainson Boat Trailer Deluxe Roller Bunk - 5' Long Sections - 12 Sets of 3 Rollers # DL21741 instead of carpeted bunks on your 2012 Deep V Tracker boat without any marks or indentations. The roller bunks provide support as well as the ease of loading and unloading. The support will not be so focused on a single location as to leave an indent or mark. I've attached a photo to give you some dimensions.

You may also want the Boat Trailer Roller Bunk Bracket for Dutton-Lainson Roller Bunks # DL21742 and CE Smith U-Bolt - Galvanized - 3-13/16" Long x 3-1/16" Wide x 1/2" Diameter - Qty 1 # CE15283GA for mounting.

expert reply by: Jason S

0

click to enlarge

Answer 1

The Dutton-Lainson Roller Bunk Bracket, part #DL21742, fits Dutton-Lainson Roller Bunks #DL21740 and DL21741. Four are needed to mount a pair of roller bunks. My contact at Dutton-Lainson advises that u-bolts are not specifically required to install…

view full answer...

Answer 2

I recommend the CE Smith Bolster And Swivel Mounting Brackets, part #CE10000G-4. These are 9 inches long and have a swivel feature that enables you to tilt the bunks to the correct angle to fit the bottom of your boat. We also carry the mounting…

view full answer...

Answer 3

I went out to the warehouse and pulled a roller bunk bracket #DL21742 to measure the slotted hole spacing for you. The slotted holes are 1-1/4 inches apart on center. I also made a short video showing this measurement for you.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 7

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 10

The size winch that you will need depends on a couple of different factors. I have included part of our hand winch FAQ below regarding boat winches and have linked the FAQ article for you to view. Finding the Right Capacity Winch for your Boat…

view full answer...

Answer 11

To add a in-bed 7-way to your 2024 Chevy Silverado 2500 to make towing with a 5th wheel easier, I recommend adding the Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector - 7' Long item #C58FV. This harness puts a 4-way and 7-way…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Recommended Roller Bunks For Tracker Deep V Boat

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching