Dutton-Lainson Boat Trailer Parts - Roller and Bunk Parts - DL21740 Review Video

The roller bunks part #DL21754 are designed to fit on the end of a 2x4 board so the width of the channel is 1-1/2 inches.

You can attach the Dutton-Lainson Boat Trailer Deluxe Roller Bunk #DL21741 directly the wood bunks horizontally if you want. I attached a picture that shows them installed on the flat side of a board for you to check out as well.

The best size replacement keel roller we have is the Yates Keel Roller for Boat Trailers part #YR12000 for black, part #YR1200B for blue, or part #YR1200Y for yellow which all measure 11-3/4" long with a 5/8" diameter shaft. The correct…

Yes, you would want to use two sets of 4 foot roller bunks since your current bunks are 8 feet long. I would recommend you go with the Dutton-Lainson Boat Roller Bunks #DL21740. These roller bunks would have plenty of capacity and would be sized…

Roller bunks don't help the water level rise, but they do help with getting a boat on or off a lift. Because your current bunks are 8 foot, you can use 2 sets of the Boat Trailer Deluxe Roller Bunk - 4' Long - 10 Sets of 3 Rollers - by…

For starters, in order to use the CE Smith Self Centering Keel Roller for Boat Trailers part #CE29505 on your boat trailer you will also need to use the CE Smith Panel Bracket for 12" Boat Trailer Rollers part #CE10305G and the Roller Shaft with…

I went out to the warehouse and pulled a CE Smith U-Bolt, part #CE15252A and took some measurements for you. The threaded portion is 2-1/16". The outside width is 4". The outside length is 3-1/8". Check out the photo of the U-Bolt…

Since you've got a boat trailer, you'll want to use something that offers a good level of corrosion resistance. We have two different u-bolts that would work for you, one that's zinc plated #CE15252A and one that's stainless steel,…

The Dutton-Lainson Roller Bunk Bracket, part #DL21742, fits Dutton-Lainson Roller Bunks #DL21740 and DL21741. Four are needed to mount a pair of roller bunks. My contact at Dutton-Lainson advises that u-bolts are not specifically required to install…

Best solution I can make for you would be to have some perpendicular cross beams welded (by a qualified welder), so that you can install the roller bunks part #DL21741 that you referenced like in the picture I attached. You will also need the install…

Going to a skinnier trailer rim like what you are looking to do shouldn't be a problem. A rim that is 1 inch thinner should work just fine. All of the 14 inch trailer tire size we offer are confirmed to fit 14 by 6 inch and 14 by 5 inch rims so…

The Phoenix USA Baby Moon Hub Cover w/ Open Center - 8-7/8" Diameter - 4 Spline - Stainless - Qty 1 #PXQ1400 has not been used for that application that I'm aware of. The splines can be removed and the overall dimensions are: With splines:…