Ark Ezi-Guides Self-Aligning Boat Trailer Loading System Review Video

The CE Smith Keel Roller for Boat Trailers #CE29505 is our only self centering keel roller. It is 12" wide versus the 8" that you are looking for. We do have the CE Smith Panel Bracket for 12" Boat Trailer Rollers #CE10305G…

I have a few options to help with loading the boat on the trailer but the best would have to be the CE Smith Keel Roller for Boat Trailers part #CE29505. In order to mount them you'd need the Roller Shaft with Pal Nuts part #CE10727A and CE…

I reached out to my contact at Dexter Axle who said that your axle is rated for 3,500 lbs and it uses inner bearing #L68149, outer bearing #L44649, and the grease seal #58846. All of these can be found in the kit #BK2-100 if you are needing to…

This will depend on the exact boat loaded on the trailer but seeing the Keel Roller #CE29505 mounted where it is only makes it understandable the boat will rest on the roller when loaded. If your boat does not touch the roller please send me a…

I recommend the CE Smith Bolster And Swivel Mounting Brackets, part #CE10000G-4. These are 9 inches long and have a swivel feature that enables you to tilt the bunks to the correct angle to fit the bottom of your boat. We also carry the mounting…

The Boat Trailer Roller Bunk Brackets #DL21742 do require 7/16" U-bolts such as #7163183UB. The bunk brackets are designed to be used with Roller Bunks #DL21740 or #DL21741.

You can use roller bunks like the Dutton-Lainson Boat Trailer Deluxe Roller Bunk - 5' Long Sections - 12 Sets of 3 Rollers #DL21741 instead of carpeted bunks on your 2012 Deep V Tracker boat without any marks or indentations. The roller bunks…

The bunks should be what's bearing the weight of the boat on the trailer and the rollers like the #CE32015G are designed to make enough contact that they guide the boat on the trailer but not fully support the boats weight. Think of them as…

The eZ-Latch on the Demco Channel Tongue Trailer Coupler #DM13689-52 does make it easier to connect the trailer and ensure the coupler latches down fully than your trigger style coupler. Since you can visibly see the latch raise and drop you know you…

90-120 ft lbs of torque is probably about right for your trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher.

I went out to the warehouse and pulled a roller bunk bracket #DL21742 to measure the slotted hole spacing for you. The slotted holes are 1-1/4 inches apart on center. I also made a short video showing this measurement for you.

You would need to have a reverse light circuit ran to your trailer to power reverse lights. If you have a 5-way flat or 7-way trailer connector currently then that circuit is already present. If you have a 4-way harness then you would need to install…