Curt Ball Mount Review C24WR Video

For a made in the USA aluminum ball mount we only have adjustable units like the Flash Secure 2-Ball Mount #DTSTBM6600-2S which includes stainless steel hitch balls as well. The Fulton #F97CR you found as well as the similar Curt #C74WR and Brophy…

It sounds like the trailer you're towing from Uhaul has a coupler height of 18-1/2" to 18-3/4", which is likely what they're referring to when they're talking about optimal height. There are a lot of factors that affect the…

The Curt RockerBalls like the part #C40047 do not require the use of a Curt ball mount or trailer hitch. They can be used in essentially any brand of ball mount or hitch.

In order to get a ball mount that has effectively 0 inches of rise or drop you would need to get a Trailer Hitch Ball Mount, part #D-4, like the one you referenced that has a 2 inch drop, and then use a 2 Inch High Rise Ball, part #C40034. I attached…

Yes, the H-Channel for Enclosed Trailer #36281-955 can be used for the side door frame on your enclosed trailer. It is specifically designed for building cabinets and doors on a trailer. There is also the 1/16" Thick Tube Trim for Enclosed…

I attached a picture that shows the CME-PCL-INS as well as a help article that covers this portion of trailer wiring installs as well. Overall it's not a difficult process but it does take some time routing it up to the front of the vehicle.…

For the Yakima Rack and Roll Trailer part #Y08107 the height from the ground to the top of the inside of the coupler where the ball sits is 22 inches so then from the bottom of the coupler lip to the ground measures 20 inches when the trailer sits…

For a 6 inch drop ball mount that is aluminum we have the Curt Ball Mount for 2" Hitches - 5" Rise, 6" Drop - 8,000 lbs - Aluminum #C24WR which would work well for you. It has a 8,000 lb capacity and weighs a total of 5 lbs. I attached…

I reached out to my contact at Curt and the Curt Aluminum Ball Mount #C84WR you were looking at measures 1" thick where the hitch ball mounts.

The closest ball mount we have to what you are looking for is the Brophy Ball Mount part #EA20 which has a 1 inch rise and is 9-3/4 inches from the center of it's hitch pin hole to it's ball hole.

Thank you for providing a photo of your trailer coupler. Trailers should always be level when hitched. If a trailer is out of level when towed it will tend to have more sway. I notice you have weight distribution (WD) lift brackets on your trailer…

I spoke with someone at Jayco who said that most of the 2019 Jay Flight SLX 8 264BH travel trailers have a coupler that matches a 2-5/16" hitch ball but since there can be some variances she couldn't guarantee that's what your travel…