Curt Two Inch Hitch Ball Review Video

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a…

The Tow Ready 2 Inch Hitch Ball, part #63845, you have referenced needs to be torqued to 250 foot pounds. It is recommended to frequently check that the ball is tightened to these specifications. If you are meaning the mounting bolts that are used…

It sounds like you are asking about the distance from the center of the hitch pin hole to the back of the shank of the ball mount that slides into the hitch. That distance is 2-1/2 inches. I attached a picture that shows this dimension as well.

On the Curt Ball Mount #C45090 the distance from the center of the hitch pin hole to the near edge of the reinforcing gusset is 3-inches. From the hole center to the end of the shank the measure is 2-1/2-inches. I prepared a photo diagram for you…

Trailer coupler height varies slightly on every trailer and every vehicle has a slightly different trailer hitch receiver height based on the hitch manufacturer. Most trailers have a coupler height between 15 and 19 inches, but there are exceptions…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

You are correct, the nut and washer of the 2 inch hitch ball #40083 are zinc coated whereas the rest of the ball is stainless steel.

Yes, the Extreme Off-Road Swing-Up Jack w/ Dual Wheels iItem #ORJW500D will work for your T@B 400 Tear Drop Trailer. It looks like your trailer comes with an a-frame jack. You would need to ensure you have enough space on your tongue to accommodate…

The nut size is 1-1/2 inches for the Curt 2" Hitch Ball - Stainless Steel - 6,000 lbs #40083.

A chrome finish ball #C40036 is going to look good but it will not be corrosion resistant. A ball with a machine finish like #C40087 , is going to have about the same corrosion resistance. In terms of performance they will wear at about the same…

The Rapid Hitch Adjustable, Aluminum Ball Mount Kit w/ 2 Greaseless Balls #AM3461 that you referenced weighs a total of 13 lbs.

There is a pin that keeps the hitch ball(s) in place on the platform. If you remove the platform of your Rapid Hitch adjustable ball mount then you can see and easily remove the pin to remove the hitch ball(s). I have linked a review video for the…