Review of Curt Trailer Hitch Ball Mount - Fixed Ball Mount - C84WR Video

Fulton ball mounts, like the #F47CR, are made overseas in China. If you were looking for something American made, you would need to go with something like the Convert-A-Ball #AMSC4. The Convert-A-Ball will have a higher 10,000 pound capacity, the…

I was able to do some digging and found out that Sure-Trac trailers use either a Dexter or Lippert axle, and both of these 3,500 lb axles use the same bearings and grease seal, so we have exactly what you need. The Bearing Kit for #84 Spindle…

I reached out to my contact at Curt and the Curt Aluminum Ball Mount #C84WR you were looking at measures 1" thick where the hitch ball mounts.

The Curt #C84WR is 2-3/4 inches wide at the ball platform, so it won't work with your #C40047 Curt RockerBall. This being said, we do offer a ball mount with a similar rise/drop with a 1 inch diameter ball hole that would work. I'd recommend…

Although we don't have a ball mount that offers the exact rise and length you mention, we offer an option that can get really close. The Curt #C84WR aluminum ball mount offers a 3 inch rise and is 8-1/2 inches long, measured from center hitch pin…

The Curt Ball Mount for 2" Hitches part #C84WR has an 8,000 lb weight capacity which is for both rise and drop positions. In regards to fit, this will vary by receiver, some are tighter than others and some are looser. It comes down to both the…

On the Yakima Rack and Roll Trailer - 66" #Y08106 the height from the ground to the top of the inside of the coupler where the ball sits is 22 inches so then from the bottom of the coupler lip to the ground measures 20 inches when the trailer…

We can definitely help you get exactly what you need to tow a 4 x 8 U-Haul trailer with your 2019 Honda Odyssey and the Curt Hitch #C64NR. According to U-Haul, their coupler height is 18 inches, and when we installed this Curt hitch on a 2019 Odyssey…

It sounds like the trailer you're towing from Uhaul has a coupler height of 18-1/2" to 18-3/4", which is likely what they're referring to when they're talking about optimal height. There are a lot of factors that affect the…

Yes, you can absolutely use an aluminum ball mount with a stainless steel hitch ball without worry of the ball mount corroding. In fact, there are no aluminum hitch balls so manufacturers suggest the use of stainless steel as it is going to be the…

We don't have a combo of the Curt Hitch Ball #C40008 and Curt Ball Mount #C45340. The ball mount is extremely heavy-duty, rated up to 17,000 pounds. I think it's safe to assume you don't have a torque wrench rated up to 450 foot pounds…

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…