Curt RockerBall Shock Absorbing Hitch Ball Review C40047 Video

I wasn't able to find the coupler height of the trailer you are interested in so your best option would be to contact who you are buying it from and have them measure from the ground to the bottom of the coupler lip with the trailer level.…

In the diagram that you referenced, that I also attached here, the brake output circuit is a separate circuit that carries power to the trailer brakes totally separate from the brake light circuits. Also, the 12 volt power source is a separate…

The break away system on a trailer would typically have its own battery, like that shown with part #20400. The reason that pulling your break away switch does not actuate your brakes is that it is not wired correctly. The break away switch should…

Going with the #C40047 Curt Rocker Ball will help isolate some of the clattering and banging from the surge coupler, and it will also help dampen some of the road shock you experience. What it won't do is help with the movement of the ball mount…

Yes Tracy, the Curt Rockerball part #C40047 does fit the Curt aluminum ball mount part #C45293 that you referenced.

The ball must be greased when using the Curt RockerBall Shock Absorbing 2" Hitch Ball #C40047. As you can see by the cut out of the linked instructions, if you don't have adequate lubrication the ball can fail so it is imperative you do. The…

What you are describing is actually pretty normal for a ball mount. There is almost always some tolerance between the trailer hitch receiver and the ball mount (or accessory) being installed which is why there are a variety of anti-rattle devices out…

To help alleviate the back and forth chucking you are experiencing with your 2 inch receiver there are a couple of things I recommend doing. First is to use a cushioned ball mount, the Convert-A-Ball, which is designed to reduce this type of movement…

Sure, if you have a tow bar that attaches to a 2" hitch ball you can use the Curt RockerBall Shock Absorbing 2" Hitch Ball #C40047. The RockerBall will function the same as any other hitch ball for that purpose.

It sounds like it may be a fuse issue. After researching the 2016 Mercedes Sprinter Manual on-line, I was able to track down the fuse box. It's located in the footwell on the left-hand side of the vehicle. If your fuses check out fine, I would…

The Draw-Tite Ball Mount - 9-3/4" Rise, 11" Drop - 9" Long - 3,500 to 5,000 lbs #80248 will bring your hitch height to 14 or 15 inches to match your tow dolly. The ball mount is rated for up to 5,000 lbs n the drop position so you…

From the base of the #C40047 up to the top of the ball measures 4.091 inches. This is about 1-3/8 inches taller than a standard ball.