Curt Ball Mounts - Fixed Ball Mount - C45014 Review Video

Take a look at the picture I have included. If the receiver on the Draw-Tite trailer hitch #24787 on your 2005 Honda Accord has that tab behind the hitch pin hole then the Class II ball mount #C45014 will not fit. But you can use #C45025 which has…

The Curt Trailer Hitch Receiver part #C11184 uses a 1/2" pin and clip like part #F-4.

Not all vehicles can handle the additional amperage draw of the trailer taillights on the vehicle taillight circuits. Even if those circuits are LED which do not draw that much relative to incandescent. Those vehicles need setup that draws power from…

Curt ball mount #C45503 measures approximately 7-3/4 to 7-13/16 inches from the center of the hitch pin hole to the center of the ball hole. From the center of the hitch pin hole to the nearest part of the welded-on ball platform it is approximately…

The power source used to test the Brophy Circuit Tester for 4-Pole Flat Trailer Connector #F4CT in the referenced video I included is the Tekonsha Bench Tester #7585. I've also included a review video for that product as well.

On the Curt Ball Mount #C45014 the distance from the center of the hitch pin hole to the back of the ball mount platform measures 6-1/2 inches.

For a 1-7/8 inch hitch ball to use with the #C45015 or the #C45014 you would want the part #A-80. For a 2 inch hitch ball you would want the part #A-82. Both of these have a 3/4 inch diameter shank that is 2-1/8 inch long.

The Curt Trailer Hitch Receiver #C98DR for your 2023 Hyundai Ioniq 5 will not reduce your ground clearance since it sits higher than the axle components on your Hyundai. It will affect your departure angle due to hanging below the rear bumper. This…

The stop inside the hitch is not to force customers to purchase certain brand products, but to ensure that a Class II draw bar is not inserted into a Class I hitch. The Draw-Tite hitch you have, part #24812, is a Class I hitch so if the welded stop…

I just spoke with my rep at Draw-Tite the bottom of the 1 1/4" receiver for the Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4" item #DT74MR sits 5 1/2" off of the ground. I have attached a picture of the…

You are probably OK but if you are anything like I am it would be too close for comfort. I wouldn't want to take a chance at potentially causing any damage to my fascia. I recommend the Curt Class II Drawbar - 5" Rise - 11-5/8" Long -…

It sounds like you may already have a 4 way connector on your vehicle, which is half of the battle. In order to operate the Curt Echo Mobile Wireless Brake Controller #C51180 you will need an almost fully functional 7 way connector; using something…