Curt Class II Drawbar Review C45014 Video

We haven't had the chance to install either the Curt #C11529 trailer hitch on the 2018 Hyundai Kona, so I'm not going to have a precise measurement for you at this time. That said, from what I can tell, based on the installation photos, this…

Based on the measurements you took on your trailer hitch and trailer coupler, you will technically need a ball mount that features a rise of around 8-1/2 inches for a completely level setup. Between the two ball mount options you mentioned, the Curt…

For your 2017 Chrysler Pacifica we have the etrailer Class 3 Trailer Hitch part #e98903 which has a pretty high towing capacity of 400 lbs of tongue weight and 5, 00 lbs total trailer weight which goes to 500/5000 when used with weight distribution.…

The Curt Trailer Hitch Receiver part #C11184 uses a 1/2" pin and clip like part #F-4.

Not all vehicles can handle the additional amperage draw of the trailer taillights on the vehicle taillight circuits. Even if those circuits are LED which do not draw that much relative to incandescent. Those vehicles need setup that draws power from…

The power source used to test the Brophy Circuit Tester for 4-Pole Flat Trailer Connector #F4CT in the referenced video I included is the Tekonsha Bench Tester #7585. I've also included a review video for that product as well.

Curt ball mount #C45503 measures approximately 7-3/4 to 7-13/16 inches from the center of the hitch pin hole to the center of the ball hole. From the center of the hitch pin hole to the nearest part of the welded-on ball platform it is approximately…

The highest rise ball mount we have for a 1-1/4 inch trailer hitch is the Curt Class II part #C45014 which has a rise of 5 inches.

Yes, the Tekonsha T-One 4-Pole Wiring Harness #118718 will work fine to power LED lights on a trailer or accessory carrier used with your 2019 Mazda CX-3 but it does require the 12V power wire connection in order to function. The plug-in connectors…

For your 2017 Honda Accord Hybrid, the Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4" #C11496 is the best fit. There are only 1-1/4 inch hitch options for your vehicle and that will only allow a maximum of two bikes even if your…

Some vehicles need a powered trailer wiring harness with a separate power wire (rather than the passive type that just plug-in) in order to protect the car's wiring. In the case of the 2016 Honda Accord sedan this is the type of harness required,…

The U-haul 5x8 trailer has a maximum GVWR (maximum recommended weight of trailer plus contents) of 2700 lbs. The trailer's tongue weight, which could be anywhere from 100 to 400 or so lbs will cause the rear suspension of your Highlander to squat…