Videos
for Marlboro
Help Articles
for Marlboro
Expert Answers
for Marlboro
The side plates on the 3" Wide Continuous Hinge #MA65VR you found are 0.09" thick which is just under 3/32". We do have a 3" Wide #MA52VR which is 6' Long with a 1/2" pin that has 0.18"…
view full answer...To properly measure your leaf springs you'll want to lift the trailer by the frame to take the weight off of the suspension and then measure from the center of the eyelet straight across the spring to the end of the slipper (pictured below).…
view full answer...We only have one piano hinge that is either 4" or 6" wide and constructed of either stainless steel or aluminum. That is the 4" Wide Continuous Hinge #MA38JR which is made of aluminum and 72" long with a…
view full answer...For a set of ramp hinges with a grease fitting the part #PLR1902 would work well for you. Overall the hinge measures 8-3/16 inches long, the end pieces are 1 inch in diameter, and the plate portion measures 4 inches wide by 2-5/8 inches deep. I…
view full answer...I do have a solution for you, but the Aluminum Car Hauler Ramp Set #288-07503 that you referenced has a max height of 16" for loading equipment. I did speak with my contact at Gen-Y Hitch who said that their aluminum loading ramps don't have…
view full answer...Yes, the 3" Wide Continuous Hinge - 6' Long - 1/4" Pin Diameter - Aluminum #MA74ZR can be cut down to fit your needs. I just recommend first removing the pin and separating each part before cutting them. You'll be better off cutting…
view full answer...The etrailer Enclosed Trailer Transition Plate #e32JR is 15" long and the width can be adjusted from 48" to 102" using the included hardware and mounting holes.
view full answer...Determining between piano hinges, #H300 3 Inch Wide Steel 6 Ft Long or #SH200 2 Inch Wide Stainless Steel Hinge 6 Ft Long, depends what features you find more important for your application. The #H300 hinge will be stronger in that it is an inch…
view full answer...The part #HP12412G is 4-3/4 inches long overall not including the grease fitting. The outside diameter is 3/4 inches. That is the portion of the hinge that gets welded to a trailer. The inner portion that inserts into the other part of the hinge is…
view full answer...The smaller section of the Z-Rail for Enclosed Trailer #362417-955 is approximately 3/4" tall, while the larger section is approximately 1-1/4" tall.
view full answer...The Longview Towing Mirrors, part #CTM1600 are fully adjustable. Typically, the OE mirrors on a vehicle drivers side are flat and the passenger side is convex. According to Longview Mirror, the driver and passenger side slide on towing mirrors are…
view full answer...The dimensions for the RC Manufacturing Trailer Tongue Box are; width at back is 36 inches, width at front is 21-1/2 inches, the height of the box is 20 inches and the depth of the box is 16 inches. You can see these dimensions in the photo I have…
view full answer...
What our customers are saying:
"I like the easy of navigation through the site. It only took me a couple of minutes to place my order. Thank You I will shop this sight again in the future."