Videos
for JR Products
Help Articles
for JR Products
Expert Answers
for JR Products
A direct replacement for your Winntec Model 6020 is the Automatic Changeover RV LP Gas Regulator #37207-30395 as the BTU rating is compatible and they have the same fitting sizes.
view full answer...Yes, the Heavy Duty Equalizer Suspension Kit part #K71-360-00 does fit your 2008 Weekend Warrior 300FS that has a triple axle setup and a 35 inch wheelbase.
view full answer...Yes, you can go with the Kit #GS69FR and it gives you the GasStop Emergency Propane Shut-Off Valve Gauges w/ GasGear Propane Hoses #GS39FR as well as the regulator. The only difference is the hoses that come with the regulator are 18" long so…
view full answer...Yes, the Automatic Changeover RV LP Gas Regulator #37207-30395 will work to replace your Winntec 6020. This regulator uses the same sized fittings as your 6020 and the BTU rating of this is compatible.
view full answer...100lb propane tanks typically have a female POL fitting so you'll just need to swap over the hoses to ones that have a male POL fitting and can still connect to your regulator/piping the same way the current hoses do. Most regulators have a 1/4…
view full answer...Those three regulators are all very similar and essentially do the same thing but they're used on different propane setups. Part #37207-30365 is a vertical regulator. Vertical regulators are commonly on propane systems on travel trailers or pop…
view full answer...I am sure we do! We have a few different styles of mounting brackets like the Taylor Made Flat Mounting Brackets for Gas Struts item #3691858 you were looking at or the Flat Mounting Brackets item #TM45YR. I have linked the rest of our selection…
view full answer...As far as specs go the Automatic Changeover RV LP Gas Regulator #37207-30395 is what you need to replace your Winntec 6020 regulator. When it comes to the mounting bolt pattern this regulator has a pattern of 1" horizontal x 3-1/4" vertical…
view full answer...The dimension of the cutout in the IP66/206 Single RV Switch Faceplate #37214035 is 1-1/2" tall and 7/8" wide. I edited a picture to show dimensions, which I have included below.
view full answer...For your race trailer with aluminum roof panels it will seal on the edges with a Butyl Tape #AL64UV. Then you will use either a Non-Sag #AL33KV or Self-Leveling #AL68KV sealant to seal the mounting screws and edges of the aluminum roof panels to…
view full answer...Hey Peter you are right that the Opti-Brite LED Strip Light #OPT32ER does require its own separate switch. For that you could use really any on/off switch, my suggestion is the Single Rocker Switch #37212585 and the faceplate #37212845. If you are…
view full answer...For your 1st question, yes the Dexter Nev-R-Adjust Electric Trailer Brakes #23-464-465 are going to fit the 5 bolt mounting flange on your 7,000lb axle for your 2020 Grand Design Solitude 380FL. For your 2nd question, yes the Trailer Hub and Drum…
view full answer...
What our customers are saying:
"I like the easy of navigation through the site. It only took me a couple of minutes to place my order. Thank You I will shop this sight again in the future."