Videos
for Taylor Made
Help Articles
for Taylor Made
Expert Answers
for Taylor Made
For a 10 lb gas strut we only have the Taylor Made Marine Gas Strut for Boat Hatches #3691835-10 which is only 20" long. Seeing as though you'd prefer a 23" long strut, the best we can offer is the Taylor Made Marine Gas…
view full answer...Yes, we do carry the covers for the Taylor Made Big B Inflatable Fender #36971034. The correct cover is the Taylor Made Boat Fender Cover #3699207R. This black cover is made specifically for the 12" diameter 34" long Taylor Made…
view full answer...Since the tongue of your trailer flares out you could just cut a piece of wood to match the angle of the flare to square up the tongue and then clamp-on the etrailer Round/Wheeled Swivel Jack #e79CR. If the trailer stays outside a majority of the…
view full answer...You will need to select the correct strut based on the weight rating for your current struts. These struts are 36" long from center of socket to center of socket and have the 13mm sockets which are the same as your 1/2". 20LB…
view full answer...The dimensions of the Torklift Rubber Camper Bumpers #TLA7001 are 8" by 2-1/2" by 2".
view full answer...I was unable to find information on the model EZ Loader Boat Trailer referenced in your question. I recommend checking the sidewalls of your existing tires to see what size is currently mounted. There should be a number listed, like what is on the…
view full answer...A foam dock bumper such as the Taylor Made Foam Dock Bumper - Edge Mount - 36" Long x 5" Tall x 3-1/4" Thick #36946011 you asked about will do a wonderful job of protecting your boat from your floating dock, but it isn't going to…
view full answer...For your 2015 Ford F-250, the BAKFlip folding hard tonneau covers will work well and there are 4 options to choose from. There is the BAKFlip G2 Hard Tonneau Cover #BAK26310, FiberMax #BAK126310, F1 #BAK72310, or MX4 #BAK48310. Each of these options…
view full answer...The portion you need to measure is not the cap, but the the hub bore. Remove the grease caps and measure the diameter of the opening the caps occupy. This is the hub bore. You will need an accurate measuring devices like a set of dial calipers that…
view full answer...For a 3x4 inch frame the best hinge kit would be the part #FHDPB350101. This is for a 3 x 5 inch frame but you could have 1/2 inch spacers welded to either side of the channel and it would and work just fine.
view full answer...You can use a strap type winch instead of a cable winch so long as your trailer's rollers are in good shape and the weight of your 28-ft Cuddy is not more than 3-times the winch's rating. Rollers allow you to use a winch rated for as low as…
view full answer...I spoke to the manufacturer Jif Marine, they informed me that the 2-Speed Boat Trailer Winch with 20' Strap part #315-W2500D would not be sufficient for a 3,500 - 4,000 lb boat even with bunk boards. The bunk boards are certainly going to help…
view full answer...
What our customers are saying:
"very easy to shop"