Videos
for MORryde
Help Articles
for MORryde
Expert Answers
for MORryde
I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but…
view full answer...The AllTrek 4000 kits provide the best cushioning so if you were to upgrade from your CRE3000 kit to the Alltrek you would see a big improvement. If you have a 35 inch wheelbase you'd want the part #MR29DR or if you have a 33 inch wheelbase…
view full answer...The hangers you currently have on your trailer are ones I have run into before. That being said, I spoke with MORryde and the #MR27ZR will still fit your trailer, but there is a modification that will need to be made. You’ll have to trim according…
view full answer...The absolute best cushioned equalizer that fits the dimensions you mentioned having would be the MORryde ALLTREK 4000 part #MR89DR as this is only option to provide vertical and horizontal cushioning. This would make a big difference and…
view full answer...The MORryde X-Factor Crossmember part #MR33WR attaches to the leaf spring hangers which are located in-between and in the front and rear of each axle. I have attached a photo below to clarify. Therefore, you'll need three for full support on…
view full answer...It looks like your MORryde ALLTREK 4000 Shock Absorbing Equalizers #MR89DR are longer than your previous equalizers were because your leaf springs are way too close to each other. The shackles should be creating more of a "W" shape…
view full answer...Finding the correct MORryde equalizer kit will be pretty specific, so I cannot tell you which will be correct without knowing the wheel spacing and axle capacity, unfortunately. With that being said, if you have the trailer's VIN, you may be…
view full answer...It is likely you can avoid the drain line when installing the MORryde X-Factor Crossmember for Standard Frame Hangers #MR33WR by using the MORryde X-Factor Crossmember Adapter Kit for Drop Down Applications #MR43WR. I don't know exactly the…
view full answer...Hey Patrick, so for your leaf spring upgrade I am going to need to know a couple of things before I can get you over to the right part. Specifically, the length from eye to eye, the spring width, leaf thickness, and the number of leaves. From here…
view full answer...You will measure the MORryde Suspension Upgrade Kit for Tandem Axle Trailers #MR76ZR from the center of each hole on the shackle strap.
view full answer...The MORryde X-Factor Crossmember part #MR33WR is designed for standard suspension so that is the one you will need to use. If your leaf spring hanger brackets are wider than 3" then you will need to drill per the instructions which I have…
view full answer...Typically a suspension bolt will be measured by the shaft of the bolt not including the head, since the head of the bolt isn't used in mounting the springs. The shackles are 3-3/4" long x 1-1/2" tall overall and the bolt holes are…
view full answer...
What our customers are saying:
"This site is top notch: Great prices, great service. Highly recommended."