Videos
for Brophy
Help Articles
for Brophy
Expert Answers
for Brophy
The Brophy Camper Scissor Steps for truck campers, #AS04, are intended for an entry height of 31" to 40". If your camper door sets within that 31-40' range then yes this will fit your rig. Please see attached image for measuring points…
view full answer...The Brophy Slide In Camper Tie-Downs #HSAB might be a fit for your 2011 Ford F-150 but you'll need to do a bit of measuring first and you'll likely need to trim out holes where the tie-downs would sit. You'll want to verify that #HSAB…
view full answer...You will need to use the Hitch Reducer 2" to 1-1/4" Trailer Hitch Receiver #HT02 which will allow you to use your Thule T2 Pro XTR #TH23JV with a 1-1/4" shank in a 2" trailer hitch receiver. Since Thule does not make a replacement…
view full answer...The Brophy Clamp On Camper Tie-Downs #HSSF will have a very slight amount of play since there is a compressible pad to prevent scratches on the bedrails, but it sounds like you're having much more significant play. I've attached a picture…
view full answer...It is too small of a space to fit the TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear - 4 Steps - 375lbs - Black Bracket Item #TLA7834 but you can instead mount it to the bumper of your camper like in the attached picture.
view full answer...Yes, the Brophy camper tie downs like the #HSAB can be used with bed rail covers. If you check out the picture I attached you can see a set installed on a bed rail with plastic covers.
view full answer...That is correct, you can tap into the plug and it will provide a charge but keep in mind that this is not the most efficient way for charging a battery. This method does not provide any charge balancing or battery charge management and on newer…
view full answer...Unfortunately we do not have a video of the HappiJac Truck-Mounted Camper Tie-Downs #LC184089 being installed. The Rear anchors are installed in the end of the bumper. There is no precise mounting location since a variety of bumpers may be installed.…
view full answer...The primary advantage of frame-mounted camper tie-downs like the TorkLift #TLF2012A and #TLF3001A, which are designed to fit your Ford F-350 if it has the 6-3/4 foot bed without a step/board underneath and a factory hitch, is the stability they…
view full answer...There is no danger of the Brophy Cable Camper Jacks #CJ31 flipping the camper over when you are using them; you just need to ensure they are properly used and aren't overloaded past their 1,000 lb (combined) capacity. These jacks have a tripod…
view full answer...Sounds like you'd want to go with a removable scissor setup like the Brophy Camper Steps part #AS24 which will need to be taken off it's mounting bracket between uses. This will give you total access to your trailer hitch when needed.
view full answer...The HSSF hold down brackets would use the Tie Down Hardware Package, part #TDHP, which includes hooks, chain and turnbuckles. The tie down hardware would typically attach to existing eye bolts built into the underside of camper. If your camper does…
view full answer...
What our customers are saying:
"very easy to shop"