Stromberg Carlson Landing Gear Replacement Lead Leg Review Video

Since Atwood is no longer in the landing gear business it is basically impossible (unfortunately) to get just a replacement leg. The part number that you gave me actually is a document that shows the various parts for Atwood landing gear, but…

The division at Atwood that handled the jacks and landing gear was sold off to Lippert so direct replacement parts are not available. But it is likely that the gear box and motor of another brand will still fit. And yes, the gear box and motor do…

Landing gear legs do typically have weld stop brackets to hold the legs securely to the welded brackets on your trailer frame. The landing gear will have a maximum capacity lift, which for the Replacement Follow Leg for Stromberg Carlson Landing…

Sounds like the correct follower leg you would need is the #LG-179014 that you referenced. The overall length of the leg is 33-1/2 inches and the distance from the inside of the two brackets is 17-1/2 inches. Check out the picture I attached for more…

The only difference between the #RVLG-8HDL and the #RVLG-8000 is that the #RVLG-8HDL includes the manual crank handle, while the #RVLG-8000 doesn't. The dimensions for both are the same. • Retracted Height of 32-3/4 inches • Extended Height of…

The Stromberg Carlson Replacement Lead Jack w/ Drop Leg #LG-179013 that you referenced, is a direct replacement part for jacks from Stromberg Carlson, Lippert and Atwood. This part's outer tube does measure 29-1/2-inches tall just like yours so…

The 8K Landing Gear Set w/ Handle #RVLG-8HDL should fit just fine as it uses the standard weld stop locations measuring 15-1/2" or 17-1/2" for the mounting brackets. I don't know what the current bracket dimensions are for your 2009…

The etrailer Landing Gear Set, part #RVLG-8000 can be used to replace the landing gear set you have on your 2007 Montana. The hand crank is available as a separate item and is part #RVLG-HDL. Most landing gears are interchangeable but you can take a…

The lead leg of your landing gear is the leg that has the motor and gear box attached to it directly. The follow leg has a connecting bar that is attached to it from the lead leg to move at the same rate as the lead leg. The follow leg does not…

Based on my research your Keystone Raptor Velocity is equipped with Venture Landing Gear. The part number M-900-PK that you found on the lead leg indicates that the correct replacement Follow Leg should be the part #LG-177201. For just the repair kit…

Repair kit #LG-146059 contains 2 pins and the drive shaft all of which are for the top of the jack. To help I have included the written instructions below and also a diagram that points out the parts mentioned in the written instructions. The…

I do have an option for you but in order to confirm the correct replacement landing gear leg screw for you, I would need to know the model number of the jack. If you can provide this for me then I can go about seeing if we have the correct landing…