Replacement Landing Gear for 2009 Heartland Sundance 5th Wheel Trailer  

The division at Atwood that handled the jacks and landing gear was sold off to Lippert so direct replacement parts are not available. But it is likely that the gear box and motor of another brand will still fit. And yes, the gear box and motor do…

Since Atwood is no longer in the landing gear business it is basically impossible (unfortunately) to get just a replacement leg. The part number that you gave me actually is a document that shows the various parts for Atwood landing gear, but…

The only difference between the #RVLG-8HDL and the #RVLG-8000 is that the #RVLG-8HDL includes the manual crank handle, while the #RVLG-8000 doesn't. The dimensions for both are the same. • Retracted Height of 32-3/4 inches • Extended Height…

The Stromberg Carlson Replacement Lead Jack w/ Drop Leg #LG-179013 that you referenced, is a direct replacement part for jacks from Stromberg Carlson, Lippert and Atwood. This part's outer tube does measure 29-1/2-inches tall just like yours so…

The etrailer Landing Gear Set, part #RVLG-8000 can be used to replace the landing gear set you have on your 2007 Montana. The hand crank is available as a separate item and is part #RVLG-HDL. Most landing gears are interchangeable but you can take a…

Repair kit #LG-146059 contains 2 pins and the drive shaft all of which are for the top of the jack. To help I have included the written instructions below and also a diagram that points out the parts mentioned in the written instructions. The…

Since Atwood is no longer in the landing gear making business and you have an older 5th wheel trailer I recommend just replacing your entire landing gear set. This not only gives you peace of mind that everything is in good shape but it also makes…

I did some checking and the 2009 Heartland Bighorn 5th wheel trailers were built on a Lippert chassis and have other Lippert components so the landing gear will also be Lippert. If you just need to replace legs then the lead leg is #LC179013 and the…

The correct replacement gear box for your Venture landing gear VMC940RB is part #LC276602. This features cast aluminum construction that will last longer than a composite gearbox like #RVLG-RDBOX which fits Ram brand landing gear model #RVLG-8000.

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Good news! I was able to go out to the warehouse and measure the etrailer landing gear #RVLG-8HDL for you. I found that the distance between the weld stops from the outside to outside is 17-1/2 inches and from the inside to the inside of the weld…