Review of Lippert Components Power Landing Gear Repair Kit - LC146060 Video

The division at Atwood that handled the jacks and landing gear was sold off to Lippert so direct replacement parts are not available. But it is likely that the gear box and motor of another brand will still fit. And yes, the gear box and motor do…

The sure way to pick out replacement landing gear for a trailer that will bolt right up to the current brackets is to measure the distance between the mounting brackets (underside of top bracket to top of lower bracket as shown in the diagram) if it…

For a replacement lead leg for your Atwood landing gear what you can use is the Replacement Lead Jack with Drop Leg #LG-179013. You just want to measure to make sure it is the right length, as this leg is 29-1/2 inches with a distance between the…

The overall dimension you are measuring is the length of the outer tube of the jack. If you check out the first picture I attached you'll see where the part #LG-1 measures 29-1/2 inches in length. The second picture I attached shows the…

Yes, the Replacement Motor for Stromberg Carlson Electric Landing Gear #LG-142178 has been confirmed to replace the ADTH 1RV-200 landing gear motor you currently have so it would work for you.

The only follow leg I can recommend you use with your Venture landing gear would be the part #LC179014. Stromberg Carlson makes the Venture landing gear, that is the brands are different but the jacks are the same. I cannot recommend you install a…

Yes, I attached a diagram you can use to install the #LC146059 that you referenced.

In order to determine if the issue you are having with your landing gear legs clicking and popping is caused by the gear box or leg assembly you will simply need to disconnect the gear box from the legs and then test each manually. If you feel…

I checked and found the manual for the Lippert Electric Trailer Jack #LC285318 and there was no mention of anything going in the hole beforehand to tighten them. I added a cut out of the manual for you which shows the parts for this jack, and it does…

I went out to the warehouse and measured the shaft included with the Lippert Components Venture Follow Leg Repair Kit #LC146060. It has an overall length right at 4 inches.

Although you did not mention if it is the lead or follow leg that is not working, if it is the follow leg it may be that you have an issue with the gearbox and would need to replace it with Replacement Aluminum Gearbox #LG-179015 which will work with…

On the Lippert #LC119226, the slot in question is 1/4 inch wide by 3/8 of an inch deep, on the #RVLG-HDL it measure 1/4 inch wide by 7/16 of an inch deep. You can see these photos in the photo I've provided.