Can Trailer Landing Gear Be Damaged Internally By Lowering Too Far?
Question:
I noticed on my old landing gear, there was a welded stop on the lower part, to keep from lowering it to far. can the landing leg be damagedinternally by lowering it to far. Thanks!!
asked by: Brand C
Expert Reply:
Landing gear legs do typically have weld stop brackets to hold the legs securely to the welded brackets on your trailer frame. The landing gear will have a maximum capacity lift, which for the Replacement Follow Leg for Stromberg Carlson Landing Gear - 33-1/2" # LG-177201 you asked this from is 34-7/8 inches. That measurement comes from the 19-7/8 inches of physical internal travel and the 15 inch drop leg. The leg can be physically overextended or retracted too far which can cause the gears or the internal threaded rod to fail.
You can replace the internal gears with the Follow Jack Repair Kit for Stromberg Carlson Landing Gear # LG-146060 which are often replaced for that very purpose.
Products Referenced in This Question
Follow Jack Repair Kit for Stromberg Carlson Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Repair Kit
- Stromberg Carlson
more information >
Product Page this Question was Asked From
Replacement Follow Leg for Stromberg Carlson Landing Gear - 33-1/2"
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Follow Leg
- Stromberg Carlson
more information >
Continue Researching
- Shop: Landing Gear Set w/ Handle - 36-1/2" Lift - 8,000 lbs
- Shop: Replacement Follow Leg for Stromberg Carlson Landing Gear - 33-1/2"
- Search Results: leaf spring
- Shop: Replacement Lead Leg for Stromberg Carlson Landing Gear - 33-1/2"
- Shop: Landing Gear Set - 36-1/2" Lift - 8,000 lbs
- Video: Stromberg Carlson Landing Gear Replacement Lead Leg Review
- Shop: Lippert Manual Landing Gear Set with Handle - Weld On - 37" Lift - 6,000 lbs
- Q&A: Mounting Brackets to Use with Landing Gear Set # RVLG-8000
- Shop: Lippert Components 32" Lead 5th Wheel RV Landing Gear Drop Leg w/Snap Pin
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Trailer Hitch
- Search Results: lg~177201
- Search Results: stromberg carlson
- Search Results: strobe light bar
- Article: Where to Position the Trailer Axle?
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Raise Your Travel Trailer Height
- Video: Review of Stromberg Carlson Camper Jack - Trailer Jack - 7145-943-00
- Q&A: Recommended Landing Gear Leg Replacements for 2008 Rag'n 30 Foot Trailer
- Q&A: Replacement Landing Gear Legs and Gear Box for 2007 KZ Sportsman
- Q&A: Replacement Jack Legs for Venture VMC900R Landing Gear
- Search Results: over under conversion kit
- Video: Curt T-Connector Vehicle Wiring Harness Installation - 2018 Honda CR-V
- Shop: Trailer Wiring
- Video: Stromberg Carlson Trailer Jack LG-BRACKETS Review
- Article: Best Camper Jacks
- Q&A: Electric Landing Gear Legs for a 2017 Sundowner 3H GN Super Sport Horse Trailer
- Q&A: How to Choose the Correct Replacement Landing Gear for 5th Wheel Trailer
- Search Results: ultra~fab products
- Search Results: landing gear