Lippert Electric Landing Gear Set Review Video

The division at Atwood that handled the jacks and landing gear was sold off to Lippert so direct replacement parts are not available. But it is likely that the gear box and motor of another brand will still fit. And yes, the gear box and motor do…

For a replacement lead leg for your Atwood landing gear what you can use is the Replacement Lead Jack with Drop Leg #LG-179013. You just want to measure to make sure it is the right length, as this leg is 29-1/2 inches with a distance between the…

The Lippert Manual Landing Gear Set with Handle - Weld On - 37" Lift - 6,000 lbs #LC333966 has a total lift of 37 inches so you can simply add that to the pictured dimensions for the fully extended lift. The Atwood name on the picture is…

Yes we do! The Lippert Electric Landing Gear Set part #LC333964 will be an exact replacement for the 2005 Keystone Montana 5th Wheel. It comes with the lead/follow legs, gearbox, motor, and anything else you need for installation. The included…

The most important metric for selecting new landing gear legs for a 5th wheel trailer is the overall length of the outer tube. The two most common measurements are 29-1/2" and 33-1/2". If you select the correct replacement based on…

It sounds like the landing gear on your Fuzion Toy Hauler may have been overextended, which likely caused damage to the internal gears and screw. This "flopping" that you mentioned is essentially the unit trying to extend but since the…

No grease or lubrication is necessary to maintain the Lippert Components Camper Jack #LC333964. According to Lippert, the only maintenance for the camper jack is to wash the jack with mild soap and water. This would be advisable after traveling in…

There are a few possibilities but more than likely they are Lippert Components because they supply most of the OEM legs for RV manufacturers. If you need to replace your legs then the Lippert Landing Gear Set, Item #LC333964, is a good option. If the…

The Lippert Landing Gear part #LC333964 will fit your fifth wheel trailer. At worst you would need to find a qualified welder to move the brackets on your trailer so that they will match up with the landing gear set. If the distance from outside to…

The Stromberg Carlson Replacement Lead Jack w/ Drop Leg #LG-179013 that you referenced, is a direct replacement part for jacks from Stromberg Carlson, Lippert and Atwood. This part's outer tube does measure 29-1/2-inches tall just like yours so…

The 8K Landing Gear Set w/ Handle #RVLG-8HDL should fit just fine as it uses the standard weld stop locations measuring 15-1/2" or 17-1/2" for the mounting brackets. I don't know what the current bracket dimensions are for your 2009…

I reached out to my contact at Lippert who said that the Atwood line has been discontinued and they don't have any replacement parts for it. Since this is the case you'll need to replace your Atwood jack. Was this for the landing gear or for…