etrailer Round Swivel Marine Jack with Wheel Review Video

The Xtreme Off-Road Swing-Up Trailer Jack w/ Dual Wheels #ORJW350D does not come with the bearings installed. You can use something like a rubber mallet or a block of wood and hammer to tap them into place until they are flush.

Yes, since your current Fulton jack is a bolt-thru style, you can use the Fulton XLT Bolt-Thru Swivel Trailer Jack #F26ZR with your current welded on bracket. You just need to remove the jack from the included bolt-on bracket and mount it to your…

A replacement for your Shelby 5138 is the Fulton Fas-Lok Coupler, 2" Ball, 3" Channel - 3,500 lbs #F223000301. This is a great quality coupler that is cost effective as you referenced. I've attached a review video of this product to…

The Extreme Off-Road Swing-Up Trailer Jack w/ Dual Wheels, #ORJW350D has an overall length of 18".

I went out to our warehouse to take a look at both the CE Smith Single Axle Trailer Fenders - 12" Grey #CE19502-2 and the larger 13" Black #CE19503-2. Both options represent the only color available from CE Smith in the respective sizes.…

Thank you for the photos! According to my information and what you sent in, your best option for a replacement fender is the CE Smith Black Fender: CE Smith Single Axle Trailer Fender w/ Top and Side Steps - #CE19503 (Qty 1) CE Smith Single Axle…

The Malone Trailer Tongue Kickstand #MPG467 is made to keep the trailer tongue 15 inches off the ground and is designed for Malone trailer tongues that are 2 inches wide by 3 inches tall. The Yakima Rack and Roll trailer has a tongue that is 2 inches…

The 15-1/2" retracted bracket height of the Fulton Bolt-Thru Swivel Marine Jack w/ Caster - Sidewind - Black - 10" Lift - 1,500 lbs #F87CR is measured from the center of the mounting bracket to the bottom of the caster with the jack fully…

We have a wiring harness for a 2023 Honda Ridgeline depending on what kind of wiring your trailer has. Both harness plug into your factory wiring behind your rear bumper. These harnesses also include the necessary fuses to activate the towing…

Ideally, you want the coupler sitting flat in direct contact with the top of the trailer tongue. If the gap between the bottom inside of the coupler and the trailer tongue is pretty minimal, say 1/16 of an inch or less, having it the way it is would…

We have a few wheel locks that will work for you. The etrailer Trailer Wheel Lock #288-02020 that works for tires up to 10 1/2" wide. Another option is the CLUB Tire Claw XL #WI491 that is designed to fit tires up to 12" wide.

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…