etrailer Trailer Jack - Side Frame Mount Jack - MJ-1206B Review Video

The CE Smith Boat Trailer part #CE48810 would be a great option for your Sportsman AutoPilot 120 as it's 12 feet long like what this trailer was designed to fit and this has adjustable angle and width bunks to best match the hull of your…

We have just what you are looking for with the Malone Bunk Kit part #MPG561 which converts Malone trailers like your Microsport to having bunks so that you could launch a boat from it.

The overall width of the CE Smith Multi Sport Plus Boat Trailer with Bunks #CE48870 is 54 inches wide.

Yes, since your current Fulton jack is a bolt-thru style, you can use the Fulton XLT Bolt-Thru Swivel Trailer Jack #F26ZR with your current welded on bracket. You just need to remove the jack from the included bolt-on bracket and mount it to your…

The frame width between the fenders on the CE Smith Multi Sport Plus Boat and Kayak Trailer #CE48870 is right at 40". As you mentioned in your question, the fenders each add a width of 7" to put the overall width of the trailer at…

There is a hole under where the handle inserts into the etrailer jack part #MJ-1206B which is where you'd spray lithium grease into to lubricate the screw and assembly.

For your 2.5 inch wide and 2 inch high trailer tongue, the Round Swivel Marine Jack w/ Wheel - Bolt On - Zinc - Sidewind - 11" Travel - 1,500 lbs #MJ-1500B is my recommendation. It will work very well with the trailer tongue you have and will…

I went to our warehouse and measured the Round Swivel Marine Jack #MJ-1206B for the dimension you asked for. When fully retracted, from the bottom of the wheel to the top of the jack tube the overall length of the jack is 23-inches. From the bottom…

The Yates Y-Style Bow Stop for Boat Trailers #YR6Y33-4 is 3 inches tall. It is 6-1/2 inches span and 2-7/8 inches wide at the base. I've attached a photo and a video to assist. This is the largest bow stop with that base size we have. I've…

The Race Ramps Wheel Chock for Vehicle Service part #RR-WC-2 will fit on the main platform of the Race Ramps Heavy-Duty XT Ramps for Service and Display - 67" Long part #RR-XT-2-HD although it may hang off just a bit depending on the size of the…

If the trailer is one that is pulled by a motorcycle or a trailer designed to carry a motorcycle, you will need a converter in order to convert the wiring system used by the 6-Way to a 2 wire system used by trailer lights. The converter you can use…

Without more information or a picture of your jack the best recommendation I could make would be to check out the link I attached that has all of the Fulton jacks we carry. You should be able to recognize the one you have by scrolling down the page…