CE Smith Roller Bunks for Boat Trailers Review Video

Since the picture you submitted belongs to Karavan I can't post it here on our site, but if you check out the attached picture you can see how a very similar trailer had a set of rollers like the part #CE27710 installed. For a set of swivel…

You can use roller bunks like the Dutton-Lainson Boat Trailer Deluxe Roller Bunk - 5' Long Sections - 12 Sets of 3 Rollers #DL21741 instead of carpeted bunks on your 2012 Deep V Tracker boat without any marks or indentations. The roller…

I recommend the CE Smith Bolster And Swivel Mounting Brackets, part #CE10000G-4. These are 9 inches long and have a swivel feature that enables you to tilt the bunks to the correct angle to fit the bottom of your boat. We also carry the mounting…

The Boat Trailer Roller Bunk Brackets #DL21742 do require 7/16" U-bolts such as #7163183UB. The bunk brackets are designed to be used with Roller Bunks #DL21740 or #DL21741.

Since your main concern is the marks on the hull of your boat I recommend going to the Yates TPR Ribbed Wobble Roller. These rollers are constructed of thermal-plasticized rubber which is a non-marking, non-scratching material. It is stronger and…

I would be happy to compare the Dutton-Lainson Roller Bunks item #DL21741 and CE Smith Roller Bunks item #CE27710 but there's not that much of a difference. Both are 5 foot long and have 6 rollers per section. Each section is rated for 1500…

I attached a picture that we recieved from a customer that shows the CE Smith winch mount #CE31013G installed and in use on a trailer for you to check out.

I apologize for all of the confusion. I can tell you with absolute certainty that the Dutton-Lainson Roller Bunk Bracket, #DL21762, will pivot to allow the roller bunk to conform to the angle of the boat or watersport vehicle's hull. The hook…

The CE Smith Roller Bunks for Boat Trailers part #CE27710 are 5' long so as long as these are close to the same length of the bunk boards you have on your trailer now they will work well for you. The CE Smith Roller Bunks for Boat Trailers are is…

I went out to the warehouse and pulled a roller bunk bracket #DL21742 to measure the slotted hole spacing for you. The slotted holes are 1-1/4 inches apart on center. I also made a short video showing this measurement for you.

I received your picture but not the spec sheet. The 10" CE Smith Deep V Keel Roller Assembly #CE10404G is a universal keel roller that helps make loading and unloading your boat much easier. The roller itself is 9-1/4" long while the…

To mount the CE Smith Winch Stand #CE31013G on a trailer requires you to slip the lower portion with the holes drilled through it over the pole tongue of your trailer. The various holes are there to allow you to match the correct height and angle…