Customers compare MT70068 to these similar products
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
The MaxxTow Adjustable Ball Mount, Part #MT70068, has a distance from the center of the hitch pin hole to the upright of 8-1/8 inches. This part includes both a 1/2-inch pin and clip to secure the ball mount, and a 5/8-inch pin and clip to secure…
view full answer...When towing with a vehicle like your 2013 Jeep Wrangler that has a rear-door-mounted spare tire you will probably need either a hitch extension like the Curt #C45796 that you referenced, OR you may be able to use an extra-long ball mount, which is…
view full answer...The Curt T-Connector Vehicle Wiring Harness #C43FV is custom fit for your 2023 Hyundai Palisade. This uses the factory style connectors used on the tail lights for your Palisade so you will not have to splice any of your trailer wiring. It does…
view full answer...I checked with Draw-Tite and they do show the Draw-Tite Sportframe Trailer Hitch Receiver part #24931 as a fit for a 2018 Infiniti Q50 all models which includes the Sport. The hitch is a bolt-on fit that will be great for towing or hitch mounted…
view full answer...It does; I verified directly with the manufacturer for you that the Draw-Tite hitch does fit your 2019 Infiniti Q50 Sport, with the correct part number being the following: - Draw-Tite Sportframe Trailer Hitch Receiver #24931
view full answer...We offer replacement rollers that could help with your situation like the part #295-000177 but what I would recommend is have your tech check out the link I attached to this page that has all of the rollers we offer and have him pick out what your…
view full answer...You can have a 2-5/16 inch hitch ball on either a 1 inch or 1-1/4 inch shank. The nut on a hitch ball with a 1-1/4 inch shank takes a wrench with a 1-7/8 inch socket. A hitch ball with a 1 inch shank will take a wrench with a 1-1/2 inch socket. You…
view full answer...The Reese adjustable ball mount, #RP21141, is designed to fit 2 inch trailer hitch receivers. Provided that your 2011 Chevy Suburban has a 2 inch receiver, this ball mount will fit. I spoke with my contact at Reese for some measurements and the…
view full answer...Both the shank portion and the ball mount portion of the MaxxTow Adjustable-Height Ball Mount #MT70068 measure 2- x 2-inches. I confirmed this by going to our warehouse and measuring both parts for you.
view full answer...The Erickson Big Hook Ratchet Tie-Down Straps #EM05715 that you referenced have two sizes of hooks. The larger swivel hooks can open enough to accept a 1-inch attachment point. The smaller safety hooks open wide enough for 3/8-inch material.
view full answer...To hook up a trailer jack to a 12 volt battery you need to make the connection from the jack's power wire to the positve post on the battery using a ring terminal, like part #DW05705-1. If you don't already have a battery on the trailer you…
view full answer...The trick here is to get as close as possible. If you are talking about less than 2 inches or so, there is nothing to worry about. Having the trailer tongue a bit too high is preferable to it being too low. You may be a good candidate for an…
view full answer...