Curt Ball Mounts - Fixed Ball Mount - C45520 Review Video

From the measurement you provided, the Draw-Tite Drawbar for 1-1/4" Hitches - 4" Rise - 10" Long - 2,000 lbs #3594 will definitely get you as close to level as possible. The Draw-Tite 1-7/8" Hitch Ball #19256 would then complete…

I checked with Draw-Tite and they list the Draw-Tite Max-Frame Trailer Hitch Receiver part #DT79MR as a fit for a 2023 Honda CR-V all models so you will be good to go with a Sport Touring. I took a look at some of the review and there were instances…

For the Yakima Rack and Roll Trailer part #Y08107 the height from the ground to the top of the inside of the coupler where the ball sits is 22 inches so then from the bottom of the coupler lip to the ground measures 20 inches when the trailer sits…

Yes, the receiver hitches that were designed for the 2014 Volkswagen Jetta will also work for the GLI model. the Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4" #C11474, because the install is slightly easier. It's custom design…

Technically, chrome is harder than stainless steel but it isn't going to be a difference between stopping a thief or not stopping one. If a thief really wants to, they'll be able to remove any lock, locks are more of a theft deterrent and…

The two Curt ball mounts you mentioned of part #C45014 and #C45015 are both options that would give you additional rise with the #C45015 being a few inches longer as well than compared to the #C45520 that you have now. Now these options only can be…

There is no standard diagram for the 5-way round connector, item #PK11501. You will need to use a circuit tester, item #PTW2993, to test the wires and wire the vehicle and trailer to match. When wiring, your green wire will be right turn/brake, the…

The Pollak 5-Pole, Round Pin Trailer Wiring Sockets, item #PK11502, and #PK11501, do not have a standardized wiring configuration. I normally direct my customers to the 6-way wiring configuration, eliminating the middle pin. Start by wiring the top…

Although there are no wiring diagrams available for the #PK11501, when looking at the front of the harness the 12 o'clock pin is the tail lights (brown wire) the 2 o'clock pin is the aux circuit (red), the 5 o'clock pin is the right…

I definitely understand being a bit overwhelmed by the amount of options in front of you, however I can definitely help with differentiating the trailer hitches for your 2019 Subaru Outback Wagon along with explaining my personal recommendation,…

The Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4" #C11474 has a hitch top inside height of approximately 9-3/4 inches. Because this is a Class I hitch receiver, the ball mount options are more limited so it is recommended to use…

It is very unusual for 4-pole trailer wiring to get hot enough to melt the 4-pole plug. This wiring format carries only basic lighting signals, no trailer brake power, no reverse lights and no auxiliary 12V power. It would be much more common for an…