Review of Curt Trailer Hitch Ball Mount - RockerBall Anti-Rattle Towing Kit - C43KR Video

Tongue weight represents the maximum amount of downward force that can be safely suspended from the hitch, whether it be tongue load applied from a trailer coupler, or a hitch mounted accessory like a bike rack or a cargo carrying tray like the…

You actually won't need to trim any rear fascia when installing any of our trailer hitches on your 2020 Toyota RAV4. Out of our selection I recommend going with the Class III Curt Trailer Hitch #C13416 because it has a 2" receiver (so it is…

If you check out the install picture I attached for the Curt hitch part #C13416 you can see that it hangs at the same height as the exhaust pipes and only sticks out a little bit past them so you'd have the same ground clearance you have now. Or…

We haven't had the opportunity to install the #EH97FR EcoHitch as of yet, but hen we installed the Curt #C13416 on a 2021 RAV4, we found that the inside top edge of the receiver tube sat about 12 inches above the ground, which would place the…

The EcoHitch Stealth Trailer Hitch Receiver part #EH84GR is a confirmed fit for a 2021 Tesla Model 3. It's an excellent bolt-on option with no drilling required. It can be used for towing (if applicable) or other hitch mounted accessories like…

You might be able to use Blue Ox pin #BX88212 which measures 4-3/8 inches between the ends so it will work. The best way to measure to ensure the clearance needed is to use a tape measure that is small enough to fit through the hitch pin holes. Then…

I checked with Draw-Tite and they list the Draw-Tite Max-Frame Trailer Hitch Receiver part #DT79MR as a fit for a 2023 Honda CR-V all models so you will be good to go with a Sport Touring. I took a look at some of the review and there were instances…

My recommendation for your 2020 Toyota RAV-4 XSE Hybrid is the Curt Trailer Hitch Receiver #C13416. The Curt is the simplest of the options available to install and provides sufficient capacity for towing uses. The RAV-4 is limited on towing capacity…

The Curt RockerBall Anti-Rattle Towing Kit #C43KR takes the additional height of the base of the RockerBall into account for the listed 4" rise and 5" drop. I have attached an image below showing how it is measured. Typically, you find the…

After you install the Curt hitch part #C13416 on your 2019 Toyota RAV4 you'll have right at 10-1/2 inches of ground clearance measured from the bottom of the hitch to the ground. I attached an install video for this for you to check out as well.

I reached out to my contact at Curt and the Curt Trailer Hitch Receiver #C13416 you were mentioned is confirmed to fit all models of the 2019-2021 RAV4 including your 2021 Toyota RAV4 Prime. If you are planning on towing with your vehicle you will…

The Yakima Rack and Roll Trailer #Y08107 referenced in your question requires a 2 inch hitch ball, such as the Curt #A-90. For optimum performance, Yakima states that the hitch ball should be installed 22 inches above the ground. You will want to…