Curved Equalizer for 1-3/4" Wide Double-Eye Springs - 5-3/4" Long - 9/16" Center Hole

See what our Experts say about this TruRyde Trailer Leaf Spring Suspension

• Replacement Upgraded Equalizer Kit for 13-104 Equalizer on Tandem Axle Trailer
  The correct replacement equalizer for your 13-104 is TruRyde Curved Equalizer # TREQ104. If you need the kit, you can use the Redline Tandem-Axle Trailer Equalizer Kit # AP233. The upgrade we offer for the 13-104 equalizer is the Dexter E-Z Flex Heavy Duty Rubber Suspension System - 5-5/8 Inch Equalizers # K71-652-00. These equalizers will replace the standard 13-104 equalizers and deliver smoother towing than standard equalizers. The rubber core will isolate and absorb damaging road...
  view full answer...
• What is the Weight Capacity of the Equalizer EQ-104
  There is no weight range for the Curved Equalizer part # TREQ104 or any standard equalizer for that matter. The weight capacity for trailer suspension is always going to be limited by its weakest component which is generally the axle. However, the above equalizer works with 1-3/4" wide leaf springs and there are 1-3/4" wide leaf springs available for 7,000 lb axles so I would not have any hesitation about uses these equalizers with up to a 7,000 lb axle. If the axle is above 7,000 lbs then...
  view full answer...
• Availability Of Equalizer 5-3/4" Long And 1-3/4" Tall For Tandem Axle Trailer
  I do have a potential solution for you. While we do not have an equalizer that matches those measurements exactly, we do have the Curved Equalizer for 1-3/4" Wide Double-Eye Springs # TREQ104. This measures 5-3/4" long and 2" tall. When replacing an equalizer we do want to keep every thing identical to stock if possible. There is going to be a small amount of tolerance. With the # TREQ104 we are looking at a difference of 1/4" each way, so it will undoubtedly be a suitable replacement.
  view full answer...
• Would Too Long of Equalizer on Trailer Suspension Cause it to Be at Angle
  If your trailer is sitting perfectly level and the equalizer is sitting at an angle then yes I would agree you have too long of equalizers and would need to go with a shorter one like the part # TREQ104 which is 5-3/4 inches. Sometimes it's just a matter of the trailer not sitting level though.
  view full answer...
• Correct Equalizer for Rvison Trailbay 31BHSS Travel Trailer
  I'm assuming that your existing equalizer is 6-1/8 inches long, measured center hole to center hole. If this is the case, we don't offer an equalizer that's 6-1/8 by 2, but we can get you really close with part # TREQ104 which is 5-3/4 inch long by 2 inches tall. The 3/8 inch shorter equalizer will slightly change the angle of your shackle links, which will actually allow a bit more suspension articulation.
  view full answer...
• Can I Replace TREQ104 Equalizers With TREQ356 And What Difference Will It Make?
  You can replace the Curved Equalizer for 1-3/4" Wide Double-Eye Springs - 5-3/4" Long - 9/16" Center Hole, # TREQ104, with the Curved Equalizer for 1-3/4" Wide Double-Eye Springs - 6-1/8" Long - 9/16" Center Hole, # TREQ356. Even though you can replace these parts, moving to a longer equalizer will cause one axle to have a disproportional amount of weight on it. The smooth transfer of the impact won't be distributed as effectively which will cause a rougher ride without as good traction....
  view full answer...
• Suspension Equalizers for 2001 R Vision Trailbay 31BHSS
  I'm assuming that your existing equalizer is 6-1/8 inches long, measured center hole to center hole, is this correct? If this is the case, we don't offer an equalizer that's 6-1/8 by 2, but we can get you really close with part # TREQ104 which is 5-3/4 inch long by 2 inches tall. The 3/8 inch shorter equalizer will slightly change the angle of your shackle links, which will actually allow a bit more suspension articulation.
  view full answer...
• Shorter Equalizer Solution for Trailer Where One Side of Equalizer Hits Frame
  Tot get your equalizer to sit level you basically just need to go with a slightly shorter one (measured from left to right). So what I would recommend is measure the length of what you have and then go with one shorter. Looking at your picture I would be willing to bet you have a 7-3/4 inch one currently so for a shorter one you could go with the part # TREQ356 which is 6-1/8 inch. Or for shorter than that we have the part # TREQ104 which is 5-3/4 inches. There would be no need to replace...
  view full answer...
  
• Using Taller Equalizer to Lift Trailer After Changing to Lower Mounting Holes on Hangers
  As you mentioned in your question, we typically recommend replacing existing hangers with taller ones to ensure you get the trailer lift you are wanting. But with that being said, in your particular application, that is what you will essentially be doing since you already adjusted the front and rear hangers to the lower mounting hole. Because of this, replacing the 2 inch tall Equalizer # TREQ104 with the 4 inch tall Equalizer # TREQ310 that you referenced will indeed lift your trailer...
  view full answer...
  
• How Do You Measure The Height Of An Equalizer?
  The height of your equalizer is measured from the center of the horizontal mounting holes, to the center of the upper mounting hole as shown as the 2" measurement in the included diagram of the # TREQ104. If you can send me this measurement, and if you are wanting a standard or cushioned equalizer I would be happy to recommend the correct replacement for you. I included a video of the # TREQ104 for you to take a look at.
  view full answer...
  
• Wiring A Trailer With A 5 Pin 7 Wire Harness
  A typical 5 pin connector will be wired as follows; Green: Right turn/brake light Yellow: Left turn/brake light Brown: Tail/running lights White: Ground wire Blue: Reverse lockout If your 5 pin has 7 wires, you likely have multiple grounds, and/or multiple running light circuits. For example if your trailer harness has two white wires you can splice the two together, and likewise with the two running light wires. This way you can wire in your 5 wire 5 pin connector. Keep in mind that...
  view full answer...
• Do Trailer Suspension Equalizers Carry Weight Ratings
  Trailer suspension equalizers like # TREQ104 do not carry weight ratings but they are available in many different sizes. They will handle as much weight as any springs you'll be using with them. Part # TREQ104 measures 5-3/4-inches between its lower hole centers and kit # AP233 includes this same item among its component parts.
  view full answer...
• Can 5-3/4 Inch Tandem Axle Equalizers be Replaced with 5-5/8 Inch Equalizers
  The Tandem-Axle Equalizer Kit, # AP233, will work as long as all other measurements are the same. Check that your shackle straps are 2-1/4 inches from center hole to center hole. The 5-3/4 inch long equalizer, # TREQ104, we carry is a direct replacement for the 5-5/8 inch long equalizer.
  view full answer...
• Which Trailer Suspension Equalizer Kit Fits Trailer with 31 inch Wheelbase
  In the past we've found that the trailers that have 31 inch wheelbases use the equalizer # TREQ104 so based on that the correct kit you'd need would be the part # AP233.
  view full answer...
• Recommend Bushings Needed For TruRyde Curved Equalizer # TREQ104
  The item you ordered, TruRyde Curved Equalizer, part # TREQ104 comes with the bushings all ready to go. For replacement bushings for part # TREQ104, you will need the TruRyde Nylon Bushing, part # TRBU11566.
  view full answer...
• Solution For Trailer Suspension Where Equalizer Is Angled When Trailer is Level
  How level does the trailer sit when towing? Could I get a picture of the equalizers as well so I can see what's going on?
  view full answer...
• Replacement Equalizer Recommendation for the Curved Equalizer TREQ104
  To replace the standard Curved Equalizer # TREQ104 with an upgraded cushioned equalizer you need the Equa-Flex Cushioned Equalizers # LC279687. These are slightly taller than what you currently have but it will still work without any issues! Attached is a review video for you to check out as well.
  view full answer...
• Will Dexter E-Z Flex Suspension Kit Work With 31 Inch Axle Spacing
  Yes, you can use the Dexter E-Z Flex Suspension Kit # K71-652-00 with 31 inch axle spacing because these equalizers are a match for your current Equalizer # TREQ104. We have contacted Dexter about this previously and so long as the equalizers are the same measurements then you can use the suspension kits so it'll fit and work as a really nice upgrade for your trailer. I have added a link to a video review for you to check out as well of the Dexter E-Z Flex Suspension Kit # K71-652-00.
  view full answer...
  
• Recommended E-Z Flex Equalizers To Replace TREQ104 Equalizers For Thunderbolt Toy Hauler
  We have just what you are looking for. The replacement equalizer you can use to replace the # TREQ104 is the Dexter Equalizers for E-Z Flex Heavy Duty Rubber Suspension, part # K71-654-00. The package contains two equalizers, bolts, and nuts.
  view full answer...
• Dexter EZ Flex Kit for 2019 Winnebago 2401 RG to Replace TREQ104
  The replacement equalizer you can use to replace the # TREQ104 is the Dexter Equalizers for E-Z Flex Heavy Duty Rubber Suspension, part # K71-654-00. This is the correct size and capacity you'd need for your trailer to replace what you have currently.
  view full answer...
• Equalizer Upgrade For 5-3/4 Inch Long Equalizers on Travel Trailer
  Based on your description of a 5-3/4 inch long equalizer that is very short, it is highly likely you have the Curved Equalizer # TREQ104. This is the same length, and measures 2 inches tall from bottom bolt hole to center bolt hole. The Road Armor are too tall to replace these, but we do have an option for an equalizer upgrade designed specifically to replace these equalizers: - Dexter E-Z Flex Suspension Kit # K71-652-00 The E-Z Flex # K71-652-00 is for axles with a capacity up to 6,000...
  view full answer...
• Cushioned Equalizer Kit for a Tandem Axle Trailer Trailer with 5200 Pound ALCO Axles
  You may be able to use the E-Z Flex kit # K71-652-00. This kit fits if the tandem axle spacing is 33 inches and if the equalizers are # TREQ104 or have the same measurements. The measurements can be seen in the picture I have included. The E-Z Flex equalizer will actually fit in place of 5-1/4 inch to 6-1/4 inch long equalizers.
  view full answer...
  
• Best Upgrade for EQ104 Trailer Equalizer
  Yes, the E-Z Flex Heavy Duty Rubber Suspension System part # K71-652-00 will be a direct upgrade for the EQ104 Equalizer. The part I really like about the E-Z Flex is that in addition to the cushioned equalizer upgrade which will help smooth out the ride you get much thicker shackle straps which will be more durable and it comes with wet bolts for easy maintenance. Therefore, it's more of a complete suspension upgrade in relation to other kits that simply replace the equalizer.
  view full answer...
• Replacement Equalizer and Wet Bolt Kit for 2013 Alcom Enclosed Trailer
  For an exact replacement the correct equalizer you'd want is the part # TREQ104. The part # K71-359-00 is a kit that includes this same equalizer but has wet bolts and heavy duty shackles and wet bolts. There isn't a similar equalizer that has the zerk fitting.
  view full answer...

Do you have a question about this Trailer Leaf Spring Suspension?