Curved Equalizer for 1-3/4" Wide Double-Eye Springs - 7-3/4" Long - 3/4" Center Hole

See what our Experts say about this TruRyde Trailer Leaf Spring Suspension

• Can 5-3/4 Inch or Similar Size Equalizer Replace 7-3/4 Inch Equalizer
  It's not uncommon for a trailer with a 29-1/2 inch axle spacing to use either 7-3/4 inch or 5-3/4 inch (or similar) equalizers but the shorter ones are more commonly used with the 25-1/4 inch leaf springs, like the ones you have, designed for up to 6,000 axles. So, the Lippert # LC279687 could potentially work for you. Keep in mind that the previous trailer owner could have been using shorter shackle straps to make up for the longer equalizers. Otherwise, an equalizer that is too long...
  view full answer...
• Solution For Trailer Suspension Where Equalizer Is Angled When Trailer is Level
  How level does the trailer sit when towing? Could I get a picture of the equalizers as well so I can see what's going on?
  view full answer...
• Why Doesn't Trailer Suspension Equalizer # TREQE34 Have Weight Capacity Listed
  The Curved Equalizer for 1-3/4" Wide Double-Eye Springs # TREQE34 that you referenced does not have a weight rating but will be safe to use basically with any trailer leaf spring suspension that has leaf springs that are 1-3/4 inch wide.
  view full answer...
• What Should the Bolt Diameter be on the Center Hanger to Use with the Curved Equalizer # TREQE34
  If by "perch" you mean center hanger, then you would want the center hole to have a 3/4" diameter like what you find on the hanger part # 115919. This will allow you to use the Shackle Bolt # TRFA73Z916DLNZ or Wet Equalizer Bolt # 126A1 with the Curved Equalizer # TREQE34 and keep the movement at a minimum.
  view full answer...
• Will 7-3/4" Long Equalizers Work In Place of 6-1/2" Long Equalizers
  The correct replacement 6-1/8" long equalizer is the part # TREQ356, not the part # TREQE34 which is 7-3/4" long. Therefore no, the two are not directly cross compatible. If the reason you are wanting to use 7-3/4" long is so you can get the kit part # e99ZR, you can use all the shackles and bolts with the above TREQ356 so getting both is what I recommend as there isn't a kit that comes with the TREQ356.
  view full answer...
• Equalizer Recommendation for Replacing One that is 7-3/4 inches Long
  The closest equalizer we have to the dimensions you mentioned is the part # TREQE34 which is 7-3/4 inches from eye to eye horizontally and then vertically 2-7/8 inches. I attached a picture of the equalizer for you to check out as well.
  view full answer...
  
• Comparison Of Trailer Equalizers TREQE34 and TREQE1
  The weight of a trailer is transferred evenly by the equalizers to the suspension system(springs, shackles and hangers), and the equalizers do not have a weight capacity listed. The equalizer allows for a smooth transfer of impact caused by rough or bumpy roads. The difference between part # TREQE34 and part # TREQE1 is the center hole with # TREQE1 having a 9/16 inch center hole and # TREQE34 having a 3/4-inch center hole. Both equalizers are designed to work with 1-3/4 inch double-eye...
  view full answer...
• Height of Equalizer in Tandem Axle Hanger Kit APT5
  The center equalizer of the Tandem-Axle Trailer Hanger Kit for Double Eye Springs # APT5 is 7-3/4 inches long (center of bolt hole to center of bolt hole) and measures 3-3/16 inches tall; it is the Equalizer # TREQE1. The equalizer that is 7-3/4 inches wide and 2-7/8 inches tall is the Equalizer # TREQE34, however this equalizer has a 3/4 inch center bolt hole while the equalizer in the # APT5 has a 9/16 inch center bolt hole. However, the most important part is the length, and since...
  view full answer...
• Additional Suspension Parts to Add an Axle to a Tandem Axle Trailer
  The first thing I need to tell you is that mobile home axles are designed for one-time use only by the manufacturers. Because of this replacement parts are nearly impossible to find. I would urge you to switch to regular axles so replacement parts are readily available. I have linked the axles we carry for you. The main problem you might run into when adding another axle is wheel scrubbing. When making turns its likely that the front axle tires will drag on the ground. Also to maintain...
  view full answer...
• Diameter of Center Hole in Equalizer in APT5 Tandem Axle Trailer Hanger Kit for Double Eye Springs
  The equalizer that comes in the # APT5 Tandem-Axle Trailer Hanger Kit is part # TREQE1. This eqalizer has a 9/16 inch diameter center and end holes. The # TREQE34 equalizer comes in the hanger kit # APT3HD. The # TREQE34 does have a 3/4 inch diameter center hole and 9/16 diameter end holes. Two wet bolts are included in the # APT3HD kit for the 3/4 inch diameter center holes on the equalizers.
  view full answer...
• Availability of Suspension Kit with 7-3/4 Inch Equalizers
  We do have 7-3/4 inch equalizers with part # TREQE34, however it is not available in a kit like the Suspension Kit # AP233 that you referenced. Since the additional components included in the kit are correct for your application, you can simply obtain the kit but add the 7-3/4 inch Equalizers # TREQE34. Otherwise, you can piece together what you are needing with # TREQE34, the 2-1/4 inch Shackle Strap # TRSL225, and the Shackle Bolt # 166081.
  view full answer...
• Recommended 7-3/4 Inch Suspension Equalizer with 3/4 Inch Center and 9/16 Inch Bottom
  The Tandem-Axle Trailer Hanger Kit for Double Eye Springs - 3-3/4" Tall Front/Center/Rear # APT5 has the wider 7-3/4 inch equalizers you referenced but all holes are 9/16 inches (top and bottom). All of our kits will have the 9/16 inch bolts. This isn't an issue unless you aren't replacing the hangers. We do have the equalizers you are seeking sold individually. They are the Curved Equalizer for 1-3/4" Wide Double-Eye Springs - 7-3/4" Long - 3/4" Center Hole # TREQE34. Then you can...
  view full answer...
  
• Replacement Equalizer, Shackles and Wet Bolts for 20 Foot Trailer with 7-3/4 Inch Wide Equalizer
  I have a solution for you, but the Dexter # K71-359-00 is not going to be a fit since the equalizer is only 5-3/4" wide. You could use the Suspension Kit for Tandem-Axle Trailers - 1-3/4" Wide Double Eye Springs - 3-1/8" Links # e99ZR, which has the correct size equalizer but does not come with wet bolts and the shackle are also slightly shorter than your 3-1/2" shackles; the shackle length won't be an issue since shackles can stretch over time but if you wanted a wet bolt kit it would...
  view full answer...
• Upgraded Equalizer Suspension Kit for Trailer With EQ-E34 Curved Equalizer
  I recommend the Dexter E-Z Flex Suspension Kit # K71-653-00 to upgrade your Curved Equalizer EQ-E34 # TREQE34. The Dexter kit includes new equalizers, wet bolts and shackle straps to quiet your trailer suspension and minimize road shock that is transferred to the trailer. I recommend using the LubriMatic LMX Industrial Strength Grease # L11390 with a Grease Gun # L30416 to fill the wet bolts. This grease is specifically formulated to work well under extreme pressure in both hot and cold...
  view full answer...
• Can Bushings in Equalizer # TREQE34 be Easily Replaced
  Considering that there is a lot of pressure on any bushings used in a suspension system it is no surprise they are stuck. And it will likely happen again. Bushings in Curved Equalizer # TREQE34 can be removed. The easiest way on it or any equalizer with bushings is to use one of the same size to drive out the old one so you are basically removing the old one and installing a new one at the same time (provided the one being installed doesn't somehow break in the process). You can use Never...
  view full answer...
• Shackles are Hitting Trailer Frame
  The best thing to do in this situation, because you have such little clearance, even with an empty trailer, is to replace your equalizers with taller ones. To pick out a compatible replacement equalizer you'll need to measure the distance between the two lower holes on your current equalizers, along with the distance between the top and bottom holes to make sure you get the correct size. For example, the Curved Equalizer for 1-3/4" Wide Double-Eye Springs # TREQE34 measures 7-3/4" between...
  view full answer...
  
• Suspension Components For Tandem Axle Trailer
  We do have tandem axle suspension kits with equalizers, but the three items you mentioned are not available in one kit. You can order # TREQE34, part # 115208GALV , and # TRFA73Z916DLNZ separately. You will just need to change the quantity you need in the shopping cart when ordering.
  view full answer...
• Do the 5,200 Lb Dexter Trailer Axles Come With Leaf Springs
  I do have the correct leaf springs that you will need to use with the Dexter Trailer Axle w/ Electric Brakes part # 6340624-EB but these are not included. If you can provide me with your leaf spring hanger spacing then I can get you the correct leaf springs and equalizers if the ones you have now will not work. That said, most trailers will have a 29-1/2" leaf spring hanger spacing and if that is the case you can use the 5-Leaf Double-Eye Spring part # e34SR with the Curved Equalizer...
  view full answer...
  

Do you have a question about this Trailer Leaf Spring Suspension?