Correct Equalizer for Rvison Trailbay 31BHSS Travel Trailer
Question:
I am looking to replace all the suspension components double eye springs, shackles, bolts and equalizers etc on my 2001 Rvison Trailbay 31BHSS double axle with T-52 AL-KO axles at 4400 pounds each. I have not pulled the suspension apart as wanted to have all the necessary parts at the ready to re-install. My question is that the current equalizer seems not to be the same dimensions of the TREQ356. I have attempted to measure the current equalizer and the top bolt to the center line of the bottom two bolts appears to be 2 inches where as the TREQ356 is 2 1/2. There are some numbers on the side of the equalizer 0-C-12-6 but have not been able to cross reference anything to these numbers.
asked by: Michael
Expert Reply:
I'm assuming that your existing equalizer is 6-1/8 inches long, measured center hole to center hole.
If this is the case, we don't offer an equalizer that's 6-1/8 by 2, but we can get you really close with part # TREQ104 which is 5-3/4 inch long by 2 inches tall. The 3/8 inch shorter equalizer will slightly change the angle of your shackle links, which will actually allow a bit more suspension articulation.
Products Referenced in This Question
Curved Equalizer for 1-3/4" Wide Double-Eye Springs - 5-3/4" Long - 9/16" Center Hole
- Trailer Leaf Spring Suspension
- Standard Equalizer
- Camper
- Car Hauler
- Utility Trailer
- Double Eye Springs
- 5-3/4 Inch Long
- Tandem Axle
- Triple Axle
- TruRyde
more information >
Product Page this Question was Asked From
Curved Equalizer for 1-3/4" Wide Double-Eye Springs - 6-1/8" Long - 9/16" Center Hole
- Trailer Leaf Spring Suspension
- Standard Equalizer
- Camper
- Car Hauler
- Utility Trailer
- Double Eye Springs
- 6-1/8 Long
- Tandem Axle
- Triple Axle
- TruRyde
more information >
Continue Researching
- Q&A: Upgraded Equalizer and Replacement Leaf Springs for 2020 Grand Design Transcend 27BHS
- Article: Double-Eye Trailer Suspension System Review
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Trailer Wheel Torque Spec Chart
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Q&A: Torque Spec for Tightening Trailer Brake Assemblies to Trailer Spindle
- Q&A: What is Bolt Hole Diameter for Suspension Hanger # E4139
- Q&A: Bolt Grade of Hardware that Comes with the Suspension Kit for Tandem-Axle Trailers AP233
- Q&A: What Are the Torque Specs for Trailer Suspension Parts
- Q&A: Does MORryde Shackle Kit Fir With Equa-Flex System
- Article: How to Raise Your Travel Trailer Height
- Article: Most Popular Wheel Bearings
- Article: Trailer Wiring Diagrams