Fulton Sidewind Bolt-Thru Swivel Marine Jack Review Video

Yes, the mounting hardware between the Fulton Jacks #FXP10 and #FXP15 are the exact same.

The Dutton-Lainson Roller Bunk Bracket, part #DL21742, fits Dutton-Lainson Roller Bunks #DL21740 and DL21741. Four are needed to mount a pair of roller bunks. My contact at Dutton-Lainson advises that u-bolts are not specifically required to…

The bolt-on Fulton Bolt-Thru Swivel Marine Jack #FXP15L comes with its own mounting kit which will fit directly on 3" x 3", 3" x 4", or 3" x 5" trailer frames, so you wouldn't need to use…

I believe I have just what you are looking for, or at least close. Take a look at the spare tire carrier and dolly bracket #DL22144. You can mount an 8 to 12 inch tire on it with 4 or 5 bolt mounting pattern and it can be used as a dolly. But it…

Standard trailer jack wheels are either plastic or metal so there isn't a rubber tire available. But we do have the Trailer Valet #STC-V211 which is both a jack and a trailer mover rated up to 500 pounds tongue. You may also be able to use…

Having 2 wheels will provide more surface area/contact with the ground. This could actually make it more difficult to maneuver compared to a single wheel. But two wheels are better than one when not on pavement. A single wheel tends to dig into dirt…

The ARK trailer jack part #ARK57FR uses a dual wheel setup with rubber tires that were designed for getting over off-road terrain which will be much easier to move by hand but the easiest would be the Trailer Valet 5X part #STC-V211 which comes with…

You can use roller bunks like the Dutton-Lainson Boat Trailer Deluxe Roller Bunk - 5' Long Sections - 12 Sets of 3 Rollers #DL21741 instead of carpeted bunks on your 2012 Deep V Tracker boat without any marks or indentations. The roller bunks…

The Boat Trailer Roller Bunk Brackets #DL21742 do require 7/16" U-bolts such as #7163183UB. The bunk brackets are designed to be used with Roller Bunks #DL21740 or #DL21741.

Yes, the Blaylock EZ Jack and Wheel Chock for Tandem-Axle Trailers #EZ-JACK that you referenced can easily still work on your trailer that has the tires only 3 inches apart. The 3 inch distance you have now is pretty common for tandem axle trailers…

I went out to the warehouse and pulled a roller bunk bracket #DL21742 to measure the slotted hole spacing for you. The slotted holes are 1-1/4 inches apart on center. I also made a short video showing this measurement for you.

I am not familiar with the exact bow stop you have pictured but we do carry a few options such as the Yates Flat Bow Stop for Boat Trailers part #YRJONBLOCK which is what I recommend using. It's designed to be used with a bracket such as the CE…