Fulton Trailer Jack - Side Frame Mount Jack - FXP15L Review Video

Yes, the mounting hardware between the Fulton Jacks #FXP10 and #FXP15 are the exact same.

What we have heard is that the Fulton #FTJ120W0301 does fit the mounting plate of the Shelby Jack 5784. This will be your best option. This jack has a 1,200 lb lifting capacity which would be more than enough.

The Fulton #FXP15 will indeed be compatible with a 3 x 2 inch trailer frame member. I've confirmed this with my Fulton representative.

Having 2 wheels will provide more surface area/contact with the ground. This could actually make it more difficult to maneuver compared to a single wheel. But two wheels are better than one when not on pavement. A single wheel tends to dig into…

I believe I have just what you are looking for, or at least close. Take a look at the spare tire carrier and dolly bracket #DL22144. You can mount an 8 to 12 inch tire on it with 4 or 5 bolt mounting pattern and it can be used as a dolly. But it…

The ARK trailer jack part #ARK57FR uses a dual wheel setup with rubber tires that were designed for getting over off-road terrain which will be much easier to move by hand but the easiest would be the Trailer Valet 5X part #STC-V211 which comes with…

Standard trailer jack wheels are either plastic or metal so there isn't a rubber tire available. But we do have the Trailer Valet #STC-V211 which is both a jack and a trailer mover rated up to 500 pounds tongue. You may also be able to use mount…

A wheel with 8 lugs will not fit your trailer hub with 5 lugs. The correct fit for the Westlake tire and silver mod wheel for a 5-lug hub is the following: - Westlake ST205/75R15 Radial Trailer Tire w/ 15" Silver Mod Wheel #LHAW121 The #LHAW121…

When measuring the wheel bolt pattern for 4 on 4 inch wheels, the measurement is taken on lug holes diagonally, not lug holes side by side. I recommend measuring your wheel again, center-to-center on lugs directly across from each other. The lug…

The standard six lug bolt pattern for trailer wheels is 6 on 5-1/2 inches. If you have a six lug bolt pattern this would be what you'd have. The pilot diameter wouldn't be an issue either as the 6 lug wheels use a large enough pilot diameter…

The travel of the Swivel Marine Trailer Jack with Caster Wheel part #DL67MR is 10" per the technical drawing from Dutton-Lainson which I have attached below.

Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The linked chart details the recommended torque for many combinations. Dexter Hub/Drum #84546UC3 has 1/2-inch studs and…