Trailer Brake Controller Installation - 2003 Chevrolet Venture Video

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

Unfortunately there is not any adapter we carry for the 7-way US to the 7 pin European. The closest thing we offer is the US 4-way to European 7-way Round #118710. To use all the US 7-way trailer functions you would need to use a European 13-way…

Nev-R-Adjusts will adjust themselves and do not technically need an initial adjustment, but they will take a few times of having the brakes applied before they will be set properly. So its not technically required that you do the initial…

The brake assemblies you have are Dexter 12 inch assemblies with a 7k capacity. That means the current part numbers you would want are #23-464 for the left hand side and part #23-465 for the right hand side. The part #23-464-465 that you referenced…

Once you have installed the Tow Ready Custom Fit Vehicle Wiring for the 1999 Toyota 4Runner, item #118341, you will be able to use the Adapter 4 Pole to 7 Pole and 4 Pole, item #37185, for the basic trailer lighting functions but you will not have…

The Prodigy P3 trailer brake controller uses a 4-wire hookup. The white wire is to be grounded to the battery negative terminal; the black power wire connects to the battery hot terminal through a circuit breaker; the red wire takes in the brake…

If your 1999 F-250 Super Duty pickup had a factory 7-Way wiring harness and the under vehicle connector has not been damaged you could use the Ford Replacement OEM Tow Package Wiring Harness, 7-Way (Super Duty), item #118243 to replace your…

We do have trailer wiring to fit your 2017 2-door Jeep Wrangler Willys but the Hopkins, part #HM42635, you asked about is not a fit. It's for model years from 2007 to 2014. If your Jeep doesn't include the tow package I recommend…

You would not need to have the computer of your 2015 Jeep Wrangler Unlimited flashed once the brake controller install components are installed. The first thing you will want is a 7-way trailer connector at the rear of the vehicle and for this I…

If the connector your Mopar 4-way connector looks like what is in the picture I attached then you could simply replace it with the part #HM42190. Otherwise you would need to use the part #37185 to adapt your 4-way to a 7-way.

For your 2014 Jeep Wrangler Unlimited with factory tow package, I recommend the Pollak 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket, Chrysler/Dodge OEM Plug Adapter #HM40975-11933. This kit gives you the wiring adapter you were asking…

You have it right so far, the 4-way connector is just as you have stated. Remember that Yellow has a L in it so that is the left side brake/turn signal and green has a R in it so that is the right side brake/turn signal. The colors for wiring a…