Trailer Brake Controller Plug-In Harness Replacement Installation - 2015 Toyota Sienna Video

To install the Prodigy P3 brake controller part #90195 in your 2007 Chevy Silverado New Body requires splicing into the brake controller wiring you have under the dash as there isn't a port under the dash. I attached an install video and a help…

Yes, we do offer a plug-in 7-way for a 2022 Hyundai Palisade, the Curt T-Connector Vehicle Wiring Harness for Factory Tow Package part #C68JR which is a plug-in fit.

Easiest solution we can offer for replacing the 7-way and lead of your Prodigy RF part #TK94FR is to hardwire in the part #H20042 in place of the one you lost. Or you could even cut the loom on both side of what you have, strip back the wiring, and…

I recommend the Hopkins Plug-In Simple Vehicle Wiring Harness #HM42245 to get the taillight functions for your 2007 Dodge Durango. This Harness will plug into the taillight connectors so that you will not have to splice the wiring on your factory…

As long as your 2021 Jeep Wrangler Rubicon 4XE has the factory trailer brake controller port underneath the dash then you can install the Curt Spectrum #C51170 without splicing into the factory wiring, but you will need to get creative with the…

To connect your vehicle that has a 4-Way flat connector to your trailer that has a 7-Way connector, you will need to install a 7-Way on the rear of your vehicle. If you just want or need the tail light functions to operate on your trailer you will…

In order to actuate the trailer brakes, you'd need a brake controller installed in the vehicle and a 6 or 7-way trailer connector. A 4 pole flat wiring harness like the #18002 you'd looked at carries 4 circuits- right turn/brake lamp, left…

On the 7-way wiring plug and lead part #H20046 there isn't a purple wire. Normally a purple wire for a 7-way is for a reverse light circuit. Which would correspond to the yellow wire of this adapter.

The Tekonsha OEM Vehicle Wiring Harness #22121 that you referenced includes all the wiring and parts necessary to install a fully functional 7-Way connector and trailer brake controller. The included brake controller harness is compatible with and…

Does your 2003 Ford Ranger already have a 7-Way trailer connector? If not then to install a brake controller you will need to also install #ETBC7. If you do already have a 7-Way connector you will just need #5506. For a brake controller I recommend…

The 2013 Wrangler Unlimited isn't equipped with a plug-in connector for installing a brake controller, but you can still hardwire the controller. The install isn't terribly difficult, we have some resources to help you though the…

There are 4 wires coming out of the back of the Draw-Tite Activator IV Brake Controller part 5504. You are correct in that the black wire runs to the positive side of the vehicle battery through a circuit breaker. The white wire runs to the negative…