How Does Prodigy P3 Brake Controller Install in a 2007 Chevy Silverado New Body

Question

Question:

I just received the Tekonsha P3 . I saw something about needing an OEM connecting harness. The box has a single plug harness, maybe just generic. Would I need to splice some wires?

asked by: Dave

0

Expert Reply:

To install the Prodigy P3 brake controller part # 90195 in your 2007 Chevy Silverado New Body requires splicing into the brake controller wiring you have under the dash as there isn't a port under the dash.

I attached an install video and a help article link that details how this is done.

expert reply by: Jameson C

0

Answer 1

Easiest solution we can offer for replacing the 7-way and lead of your Prodigy RF part #TK94FR is to hardwire in the part #H20042 in place of the one you lost. Or you could even cut the loom on both side of what you have, strip back the wiring, and…

view full answer...

Answer 2

I recommend the Redarc Tow-Pro Elite Brake Controller for Tekonsha Harness item #RED63RR. This brake controller and harness will install inside your Silverado without cutting or splicing wires using the Tekonsha Plug-In Wiring Adapter item #3064-P.…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The P3 brake controller, #90195, will go into a sort of sleep mode after it detects no movement for 15 minutes. While it is on it does not draw very much power. What you can do to make sure it goes to sleep is exit the truck after turning it off,…

view full answer...

Answer 5

To install the Tekonsha Prodigy P3 Trailer Brake Controller #90195 in your Freightliner S2RV chassis the wiring is behind the kick panel in the drivers compartment. There is not a connector on the wires, they are simply terminated with tape. You will…

view full answer...

Answer 6

Hey Scott, If you're wanting a brake controller that will plug into your factory wiring harness and won't give you any errors then I recommend going with the Tekonsha Prodigy P3 #90195 along with the Tekonsha Plug-In Wiring Adapter #3034-P.…

view full answer...

Answer 7

Hey HPA, I would go with the Air Lift kit part #AL64VJ that fits your 2019 Toyota RAV4 based on what you described and your needs. This gives you adjustable support that you can tailor as needed so that you get the exact amount of support you need…

view full answer...

Answer 8

Sure thing, I will go ahead and list out what you need for your 2023 Kia Sportage to add a 7-way for a brake controller so you can tow with the Curt Trailer Hitch Receiver #C94WR: - T-Connector Vehicle Wiring Harness with 4-Way Flat Trailer Connector…

view full answer...

Answer 9

Yes, the lid is available as a replacement part. Based on the part numbers you gave me the correct replacement lid is the #FVK1020-19. For the lift arm you can use the #FVK8011-05.

view full answer...

How Does Prodigy P3 Brake Controller Install in a 2007 Chevy Silverado New Body

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching