Review of etrailer Trailer Locks - Coupler Locks - E98887 Video

Hi Ed, If I'm understanding you correctly your trailer's frame is 3" wide and the coupler needs to have a 2" ball. If so the Demco Channel Tongue Trailer Coupler #DM15000-52 you were looking at would be a compatible fit. I've…

The correct Dexter Trailer Springs Over-Under Conversion Kit for a Big Tex 35ES Single Axle Utility Trailer with Dexter 3,500 Lb Trailer Axle is part #K71-384-00.

Based off the measurements you provided, you've got a #84 spindle, so the correct bearings are the #L44649 and #L68149, and #RG06-050 grease seals. We typically try to put bearing numbers of popular manufacturers on the bearing pages but those…

As long as the tongue on your boat trailer does not exceed 3" wide, I recommend using the Demco Channel Tongue Trailer Coupler part #12564. This coupler fits a 2" hitch ball, has a 10,000 lb weight capacity, and comes with a zinc plating…

You can get those locks all keyed alike, but there isn't a set with all three together. Instead, what you'd do is go to the product pages of each, and on those product pages there is a drop-down box that says "Keyed Alike?" and…

Yes, the Trailer Coupler Lock #e98887 that you referenced will work with a UFP A-60 coupler lock. The product picture for this lock shows it being used on an A-60. I attached a review video for you to check out as well.

Yes, I do have the exact dimensions you need of the Demco Channel Tongue Trailer Coupler part #DM15945. I have attached these for you below.

Yes; your car hauler trailer has to have an A-frame and be within the correct weight rating, but if so you can definitely use the Demco A-Frame Trailer Coupler #DM14793-52. The #DM14793-52 has a 10,000 lb capacity so that's the most your loaded…

I definitely understand how safety chain capacities and determining exactly what chain rating you need for your trailer can be a bit confusing. To keep it as simple as possible, safety chain requirements state that the breaking strength of EACH…

The Trailer Coupler Lock #e98887 will work with a UFP A-60 coupler like your Dexter A-60 #DX56FR. The product picture for this lock shows it being used on an A-60.

The best way to jack up a boat trailer with torsion axles, or straight axles for that matter, is to use a trailer jack that is rated high enough for the weight of the trailer at the point the jack is installed. Going with a higher capacity than…

It sounds like you are referring to a coupler latch lock that is used to lock the latching mechanism of the coupler onto the hitch ball. If this is the case then you would want to use a 1/4" diameter pin like part #e98886. I have attached a…