Curt Hollow Shank Accessories Anti-Rattle Kit Review Video

Thule doesn't make a round bar. They are known for square bars and more recently aero shaped bars. Yakima on the other hand is more known for round bars like the part #Y00410 for a quantity of 2 66 inch round crossbars.

The Class III Curt trailer hitch part #C13418 that you referenced has a 5/8 inch diameter hitch pin hole which is standard for the 2 inch hitch size. So the Curt anti-rattle device 22323 part #C69HR would fit.

I have some information that will help us determine if the air bags included with the Air Lift Ride Control Helper Springs, #AL59561, will work for you, however, we have not received any complaints of these air bags being too tall or causing fit…

When determine if you can fully open swing-out doors on your 2022 ProMaster 3500 with the Yakima EXO #Y34ZR, it really depends on how far your doors swing when in the open position. While the 90-degree swing has not been tested spcificially on a 2022…

Trailer hitches as well as adapters have some tolerances that means they may not be exact in regards to the opening being 2 inches or an adapter being fully 2 inches such as you may be seeing with the Curt Trailer Hitch Receiver #C13392. So what you…

You will need the Repair Kit #RM910003-85 for your Roadmaster Falcon All Terrain, Non-Binding Tow Bar #RM-522. You should not have any need to replace the Inner Arm #910021-65 or Latches #910003-45 unless there is very noticeable wear on these…

On the Curt Ball Mount #C45090 the distance from the center of the hitch pin hole to the near edge of the reinforcing gusset is 3-inches. From the hole center to the end of the shank the measure is 2-1/2-inches. I prepared a photo diagram for you to…

It sounds like you are asking about the distance from the center of the hitch pin hole to the back of the shank of the ball mount that slides into the hitch. That distance is 2-1/2 inches. I attached a picture that shows this dimension as well.

Since you're already wanting to utilize your truck bed for transporting your kayak I recommend picking up the Flint Hill Goods Truck Bed Extender #FHG89ZR as it allows you to secure and support the end of your kayak that hangs out the back of…

The etrailer cargo carrier #e34FV does not have a speed limit/rating. So as long as you are going a reasonable speed for the conditions of the road it will be perfectly fine. The weight in the carrier does not matter either. I am probably supposed to…

Yes, you can install the ball of the Curt RockerBall 2-5/16" Shock Absorbing Hitch Ball and Ball Mount w/ Sway Control Tab #C45WR in the rise position if you wanted which would give you the rise of 3/4 inch that you mentioned.

The ball of the Curt RockerBall 2-5/16" Shock Absorbing Hitch Ball and Ball Mount w/ Sway Control Tab #C45WR is not installed or torqued down when it arrives. You'll need to torque the nut to 250 ft lbs.