Mounting Hole Pattern of the Demco Channel Tongue Trailer Coupler DM15945

Question

Question:

Is there a schematic that shows length of the Coupler together with the distances between holes and the distances from top and bottom and end to the Holes ?

asked by: XAB

0

Expert Reply:

Yes, I do have the exact dimensions you need of the Demco Channel Tongue Trailer Coupler part # DM15945. I have attached these for you below.

expert reply by: Conner L

0

Mounting Hole Pattern of the Demco Channel Tongue Trailer Coupler DM15945
(click to enlarge)

Answer 1

Yes, the etrailer coupler part #CT-5003-Z is an exact replacement for the Ram coupler you have now. The mounting holes are the exact same dimensions.

view full answer...

Answer 2

The only way to add a 3" coupler like the Demco item #DM15945 to a 2" wide trailer channel is to weld 1/2" plates of steel on both sides of your coupler and drill all new holes. If you have a welder this is extremely…

view full answer...

Answer 3

Yes, the mounting holes for the Channel Tongue Trailer Coupler #CT-5003-Z measure 1" from the center down to the bottom of the channel.

view full answer...

Answer 4

The 168255TC oil seal is designed for use on for oil bath hubs, but they can be used on grease hubs. They basically just provide a better seal to hold oil in; they will still work for grease. The springs on your oil seals are required to function…

view full answer...

Answer 5

We do have a compatible grease seal for your 168255TC oil seal, however, we do not carry rubber coated seals in this size. The 168255TC oil seal was designed to work with oil bath hubs on a 3,500 lb axle. For the most part, axle manufacturers have…

view full answer...

Answer 6

I do have an option for you but I cannot give you exact bearing numbers for your trailer unless provided with spindle measurements or the trailer's VIN (if the manufacturer is still in business). I can however tell you that the two most common…

view full answer...

Answer 7

For the Demco #DM13689-95 eZ-Latch coupler, we recommend the #e98887 which would install into the hole indicated in the photo I've provided.

view full answer...

Answer 8

Getting no brakes while reversing will be due to having a surge actuator. As this type of actuator applies the brakes by pressure on the coupler and there will be no forward pressure when you are reversing down a slope, it will not apply the brakes.…

view full answer...

Answer 9

There is no specific torque rating for the castle nut that holds your hub in place. We recommend tightening the castle nut down until it stops, and then backing it off to the next notch wheel the tang washer will fit into the castle nut. Over…

view full answer...

Answer 10

Although there is no specific measurement for that space between the bearing and grease seal, when installing the seal you will only insert it enough so that it is flush with the hub. This is the same case if you are installing the Bearing Kit…

view full answer...

Answer 11

The nut on the spindle should be tightened until snug, with no side-to-side play in the hub and then backed off slightly, about maybe a 1/8 of a turn. If the spindle uses a castle nut and cotter pin or tang nut, tighten the nut finger tight until it…

view full answer...

Answer 12

The width and height of the BoatBuckle Vertical Rod Hold-Down PLUS System #IMF15435 are both approximately 2" while the length is 11-1/2".

view full answer...

Mounting Hole Pattern of the Demco Channel Tongue Trailer Coupler DM15945

Product Page this Question was Asked From

Continue Researching