Replacement Trailer Bearings for Shoreland’r Trailer with #84 Spindle  

Based on the measurements and bearing numbers you provided me. We have the individual parts you need. You'd want the bearing part #LM67048 and #L68149. Since the inner diameter of bearing #LM67048 is 1.250 inches and the inner diameter of…

In order to find the correct replacement hubs for your Shoreland'r boat trailer, you need to first know what bearings your current hub has. You will need to take apart your current hub assembly and look at the bearings themselves; wipe away the…

Yes, you will need to remove the paint in order get a better ground connection for your trailer's lights. This is a super common issue that we see and you nailed it with the solution you described. A lot of the time the aluminum is usedfor boat…

It sounds like you have a wishbone wiring harness install on your trailer. A regular 4-way wiring harness has 4 wires from the back of the connector, 1 for left turn/brake typically (yellow), 1 for the right turn/brake typically (green), 1 for the…

Are you positive that the bearing number you have is 15126? That is not a standard bearing number and based on the other bearing you have it sounds like you would need the part #BK3-100. If the inner diameter of the 15126 is 1.250 and the matching…

Thank you for providing that information. According to ShoreLandr your current hub uses #L44649 inner and outer bearings. That means you can use the Trailer Idler Hub Assembly for 2K Axles - 13" to 15" Wheels - 5 on 4-1/2 - Pre-Greased…

If you obtain the Spindle Grease Seal Set part #BB60005 with the Trailer Idler Hub Assembly part #AKIHUB-545-35-EZK then yes, this will be a direct replacement for your Shorelander SS734 Trailer Hub

From the research I did the SS734 bearing/hub kit is designed for a number 84 spindle so the correct hub is the part #84545UC1-EZ.

Based on the dimensions you mentioned you have a 3,500 lb axle on your Shorelandr SV2042T so the correct bearing kit you'd need is the #BK2-100.

DOT 3 or DOT 4 brake fluid is recommended for Demco brake actuators like the #DM72VR. You should never use DOT 5 as it will wear out seals very quickly.

DOT5 brake fluid is what you'd want to use in the Dexter surge actuator part #DX89FR. If the breakaway pin was pulled it would be replaceable. The breakaway cable is replaceable.

Thanks for giving me the dimensions and part number of the hub you are looking for. Based on that I can tell that you have a BTR spindle on your trailer. I also was able to determine that you need a bolt pattern of 5 on 4-1/2 inch with 1/2 inch…