Tekonsha Brake Controller 3034-P Review Video

On the 2014 Ford F-53 chassis the brake controller port is located on the left hand side of one of the steering column supports. The plug is gray in color, and you should be able to see it if you look to the right of the emergency brake release…

Your 2014 Fleetwood Bounder should be on a Ford F-53 chassis. If you found the gray plug next to the brake release (see attached photo) then this means that you should just be able to use a plug-in adapter to easily install your brake controller. Out…

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

The #L68110 Race in my application charts works with the #L68149 bearing. We do show that the #L68149 bearing also works with the #L68111 race and this may be the application you need. The #L68149 inner bearing is paired with the #L44649 outer…

The brake controller I recommend for your 2018 E-450 is the Prodigy P3, part #90195. This is one of our most popular because it is easy to install and operate. You will also need a plug-in adapter, part #3034-P. This will plug into the harness on…

I'd recommend unplugging the existing adapter out of the connector you found, and replacing it with the #3035-P adapter harness. I couldn't begin to tell you what the yellow wire on the vehicle was used for. An orange wire on the adapter…

The #3035-P is the brake controller adapter for a Ford truck, so it's not going to be the correct adapter in this case. From what I was able to find in my research, it looks like the Ford E450 chassis RVs actually use the #3034-P adapter to…

I would start by inspecting the connector on your trailer and the vehicle to make sure there is not corrosion in the connector which could be causing a bad or weak connection. If there is corrosion in the trailer side connector, you would need to…

The Tekonsha Prodigy P3 Trailer Brake Controller part #90195 will go into a sleep mode after 15 minutes of inactivity. Therefore, with the vehicle shut off and the key out of the ignition it will still stay on till the 15 minute window is reached.…

I apologize for any confusion on what the proper torque specs are for 1/2 inch lug nuts on trailer wheels. I attached a picture of a chart to the right that details what the proper torque specs are for a trailer wheels lugs based on lug size, wheel…

If you sever the blue wire leaving the P3 controller part #90195 leaving enough room to reconnect it and test the end of the wire leaving the controller with a circuit tester like part #PTW2993 you should see voltage when you slide the manual…

The blue wire is for brake output power to the trailer brakes. One end connects to the brake controller and the other end goes to the pin in the trailer connector on the vehicle side that is for the trailer brakes. The Adapter 6 Pole to 7 Pole…