Review of Reese - Weight Distribution - 58133 Video

Yes, the Pro Series Weight Distribution Shank part #RP63971 will fit your Pro Series system. Almost all of the weight distribution systems make their shanks to fit the standard size of holes that are 1-1/4 inch apart on center and are 3/4 inch in…

With an aluminum frame trailer, you need to check with the trailer manufacturer to determine if weight distribution can be used. Many companies won't allow it. To help with sway when a weight distribution system with sway control isn't an…

I looked up the fender part number you mentioned and while the info was pretty limited I was able to determine that the Fulton fenders part #F008574-2 would be a suitable replacement and would work great.

Everything sounds good with your installation. The Reese Dual Cam #RP26002 often makes the weight feel lighter than just the Reese Weight Distribution #RP66020 since the bar is sliding on the cam. As long as your vehicle is still leveling out…

The Replacement Bolts and Washers for Reese High Performance Trunnion Weight Distribution (WD) Head #58133 that you referenced is compatible with the Head for Reese Weight Distribution System #RP58167 that is used for your discontinued 66152 WD hitch…

We can help you find a suitable hitch for your 2001 Mazda MPV. For your 2001 Mazda MPV we do offer two sizes and classes of trailer hitch receiver, both a 1-1/4-inch Class II type and a higher-capacity 2-inch Class III. Correct fits for these will…

The Brophy D-Ring Tie Down Anchor w Backing Plate - Bolt-On - 1/2" Wide - Recessed - 1,600 lbs #RR5K will work well on 1/2 inch plywood decking as long as you use the backing plate. The recessed anchor will actually sit below your plywood, but…

Depends on the condition of the wood but the backing plate of the Brophy D-Ring Tie Down Anchor w Backing Plate #RR5K that you referenced is designed to distribute the weight so that it does not easily rip through the wood. I attached a picture of…

I went out to the warehouse and the large 3/4 inch bolts used on the Reese round bar weight distribution head #RP58112 require a 1-1/8 inch socket or wrench. For information on torque specs please refer to the instructions I have linked for you.

You will need a 1-1/2" wrench like part #C20001 in order to install the nut on the 2" Hitch Ball part #63845. A 1-7/8" wrench would be much too large.

The Tow Ready 2 Inch Hitch Ball, part #63845, you have referenced needs to be torqued to 250 foot pounds. It is recommended to frequently check that the ball is tightened to these specifications. If you are meaning the mounting bolts that are used to…

If you have a Reese weight distribution system then we have replacement bolts and washers #58133. The bolts are not stainless steel or chrome. For that you would have to get some locally rated grade 8. If you want just the washers use #58024.