Jack Recommendation for Replacing Shelby Jack 5784
Question:
Good afternoon, It looks like you have probably answered this, but I wanted to double check. I have a Shelby 5784 jack that I lost the handle to. It is a weld-on bolt-thru. The bolts pattern to the welded plate is 3inch x 5-1/2inch and the pin hole pattern is about 3inch square. From what I can tell, it appears the best approach is to replace the jack using the bolt-thru bolt to attach the new jack to the existing plate. Is that correct and is the Fulton Trailer Jack - FXP10W0301the best bet? Is there any benefit in going up to the 1500# Fulton Trailer Jack - F141132? Again, sorry if youve answered this a thousand times. I have pictures of everything if that would help. Thanks so much,
asked by: Justin M
Expert Reply:
What we have heard is that the Fulton # FTJ120W0301 does fit the mounting plate of the Shelby Jack 5784. This will be your best option.
This jack has a 1,200 lb lifting capacity which would be more than enough.
Product Page this Question was Asked From
Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1.2K
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Weld-On
- With Wheel
- Fulton
more information >
Continue Researching
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Can I Use Different Grease w/ the CE Smith Trailer Idler Hub Assembly?
- Article: Trailer Wiring Diagrams
- Article: Most Popular Wheel Bearings
- Article: Best Boat Trailer Jacks
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Correct Replacement for AL-KO 7230 Hub/Drum and Brakes
- Q&A: Best Replacement for Atwood 82543 Brake Actuator
- Article: Trailer Lighting Requirements
- Article: Trailer Jacks
- Q&A: Measurements Of The Ark Drop Down Jack When Folded Into Stored Position And Retracted position
- Q&A: Dimensions of Weld-On Plate for Ark Drop Down Corner RV Stabilizer Jack Kit
- Q&A: Recommended Replacement Stabilizer Jacks For A 2011 K-Z Durango 1500
- Q&A: Jack Recommendation for a Triton Boat Trailer