Review of CE Smith Boat Trailer Parts - Guides - CE27660 Video

Yes, you can change the angle of the bunks in the CE Smith Bunk-Style Guide-Ons #CE27660. The brackets that hold the bunk boards are bolted to the tops of the posts so once the angle needed is set you would tighten those bolts to keep that angle.

For the Maggie Rack on your vehicle we will need to go with a different direction other than the Inno Feet #INXP that you referenced. I reached out to my contact at Inno who said that these are a bit more specific in what they fit and they…

You could flip the CE Smith Post-Style Guide-Ons for Boat Trailers #CE27620 mounting bracket upside down and just shoot some self-tapping screws through the diamond plate step, but this wouldn't provide as much strength for the posts in the…

One solution could be to install one of the bunks of the CE Smith Bunk Guide Ons #CE27660 in front of and behind the fender wells of your trailer since we don't have any longer than 5 feet like the kit part #CE27600.

The CE Smith Bunk-Style Guide-Ons you mentioned, part #CE27660 will work on trailer frames up to 3 inches wide by 4-1/4 inches tall, therefore they would work just fine with your trailer. The attachment brackets allow you to fine-tune the width of…

When you set up a set of guide ons like the part #CE27660 you wouldn't want them to contact both sides of the boat at the same time. You would want an inch or two of clearance between the boat and the uprights.

For bunk style guide-ons such as #CE27600 the bunk board and boat should only barely touch if at all. There isn't a hard and fast rule that says it should be this many inches. But since guide-ons are not meant to support weight like a regular…

It sounds like you're describing something like the CE Smith Bunk-Style Guide-Ons for Boat Trailers #CE27660. Guide-ons are pretty universal fits so as long as your frame matches the 3" wide x 4-1/4" tall specs for the U-Bolt kit and…

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

I have another option for you, but the CE Smith Bunk-Style Guide-Ons for Boat Trailers - 60" Long - 1 Pair #CE27600 you were looking at are designed for standard boats and not Tritoons. Instead I recommend the CE Smith Bunk Style Guide-Ons for…

The best way to determine the height needed is to measure from the top of your trailer frame to the top of the sides of your boat. If the 40" Tall Guide-Ons #CE27626 sit right at or slightly above the sides of your boat then the shorter will…

On a boat trailer you will need to position the bunks so that the boat is resting against them. there should not be a gap between the bunks and the boat. A gap would allow the boat to move around on the trailer which is something that you do not want…