etrailer Channel Tongue Trailer Coupler Review ct-5003-z Video

To mount the Channel Tongue Trailer Coupler - Trigger Latch - Bolt On #CT-5003-Z, I recommend using 1/2 inch bolts. The higher the grade, the stronger the bolt. I've attached the review video to help as you plan this installation.

I went out to our warehouse to take a look at both the CE Smith Single Axle Trailer Fenders - 12" Grey #CE19502-2 and the larger 13" Black #CE19503-2. Both options represent the only color available from CE Smith in the respective…

I can help you pick out the correct hub, but we don't have a cross-reference part number for the one you listed. In order to pick out the correct hub assembly for a trailer you are going to need know a few key pieces of information. The…

The UFP H-1377B hubs you have are 3,500 lb axle hubs so for a replacement you could use the Easy Grease Trailer Idler Hub Assembly for 3.5K Axles part #AKIHUB-545-35-G-EZ-K which is a direct replacement. The correct Bearing Buddy would then be the…

A Bearing Buddy can install on a EZ lube hub/spindle but you are going to have to take the zerk fitting off of the spindle to allow the Bearing Buddy to fit and have the needed clearance. You can yank it off with a pair of pliers or vice grips. If…

Yes you can use a Bearing Buddy on your current axle setup but you'll have to remove the zerk/grease fitting. What you have now is an EZ lube spindle which allows you to push grease through the middle of the spindle but you can install a Bearing…

Yes, the mounting holes for the Channel Tongue Trailer Coupler #CT-5003-Z measure 1" from the center down to the bottom of the channel.

You are correct that the Atwood 82311 is no longer available, but there is a similar coupler with the same specs, which are a 3,500 lb capacity, couples to a 2 inch hitch ball and fits a 3 inch channel. For that I recommend the Trailer Coupler…

The grease zerk used in their EZ Lube spindles like #TRU74FR is a standard 1/4-inch pipe thread fitting that you can replace with an item like #Gzerk. Your local hardware store may have one too. You can use a grease gun kit like #L30132 on this…

I recommend etrailer.com Channel Tongue Coupler part #CT-5003-Z to replace the Shelby 5135 coupler. The etrailer.com coupler has a channel width of 3" and takes a 2" ball. It also has 3" from center of bolt hole to center of bolt hole…

The inner dimensions of the Channel Tongue Trailer Coupler #CT-5003-Z are 5" from the bend to the rear of the coupler, 3-1/6" wide and 2-1/8" tall. I have created a diagram with these measurements below.

We offer two clevis pins that come close to the dimension you're looking for. The #MT70053 measures 5/8 of an inch in diameter and 3-5/8 inches long. Part #586H measures 5/8 by 6 inches long. If you were looking for a replacement clevis pin for…