etrailer.com Trailer Hitch Receiver Installation - 2013 Toyota Tacoma Video

The HydraStar Marine Electric Over Hydraulic Actuator w/ Breakaway and 7-Way RV Harness #HS381-9067 will work great for your 10K boat trailer as long as you have disc brakes on your tandem axles. If you have drum brakes then you need the kit…

There are three trailer hitch receivers that are fits for a 2005 Toyota Tacoma, and according to the manufacturers, from outside-to-outside at the widest points the hitches were approximately 38-1/2 inches wide. That would be the part of the hitch…

I have attached a basic brake controller wiring diagram for you. You will want to make sure that you ground the white wire to the negative post on the battery. The black wire will attach to the positive battery post. The red wire will tap into the…

You likely can use any replacement switch since all they do is complete a circuit when the pin is pulled out. One wire on the switch should be connected to the positive battery terminal on the trailer. The other will tee into the wiring leading from…

The three wires of the Tekonsha Breakaway System part #50-85-313 will get wired as follows: The white wire attaches to the ground wire. The blue wire attaches to the brake output circuit that goes to the brake assemblies of the trailer. The black…

It sounds like you have an aftermarket trailer wiring harness. Whether it is aftermarket or factory, that clicking noise you hear and the trailer lights not working indicate that there is a problem internally with the converter and it will need to be…

The only compatible Draw-Tite trailer hitch receiver for a 2008 Toyota Tacoma is the Draw-Tite Max-Frame Trailer Hitch Receiver #75236, which excludes X-Runner models. If you have a regular Tacoma then you'd be fine using that hitch. If you do…

Since your 2015 Toyota Tacoma doesn't have a hitch or trailer wiring already the wiring harnesses we carry that fit plug in to connectors that are either along the frame rail or behind the tail lights. If you can't find a connector under the…

4-Way to 5-Way adapters #47515 and #20036 are essentially the same. The difference is that #20036 has longer wiring with it than #47515. For that reason we normally recommend #20036. The 4-Way to 5-Way portion is 18 inches long. The blue wire though…

The bumper does not need to be removed when installing the Curt Trailer Hitch Receiver - Custom Fit - Class III part #13323 on a 2009 Toyota Tacoma, but three of the bolts that hold the bumper in place will need to be loosened and two will need to be…

I'm not sure why but I can tell you that the part you're looking at, Hopkins Plug-In Simple Vehicle Wiring Harness #HM11143910, is a fit for the Lexus 570 but not your 2005 Toyota Tacoma. To install a 7-way trailer connector on your truck you…

The only way to verify if your 2006 Toyota Tacoma will accept the Tekonsha Plug-In Wiring Adapter #3040-P is by finding out if it came with the factory tow package. We have only installed this on one 2nd generation Tacoma in our shop and it was a…