Review of Hydrastar Brake Actuator - Electric-Hydraulic Brake Actuator - HS481-8067 Video

The Hydrastar Vented Marine Electric Over Hydraulic Actuator for Disc Brakes #HS481-8067 is designed to be completely plug-and-play so the female end of the 7-way would need to connect to the 7-way cable that's already installed on the…

The HydraStar Marine Electric Over Hydraulic Actuator w/ Breakaway and 7-Way RV Harness #HS381-9067 is designed to work with an aftermarket electric over hydraulic brake controller. This kit will require you to wire in the components using the wire…

You can lock out your surge brake actuator although it's not always the prettiest of solutions. You need to either weld the pieces together or drill holes through it putting in bolts to keep it from moving. It'll work but it…

As shown in the provided photo, the approximate distance from the centerline of the trailer ball to the end of the coupler is 12 inches. The Demco #12564 accepts a 2 inch trailer ball.

The only difference between the Demco Channel Tongue Trailer Coupler part #12564 and Demco Channel Tongue Trailer Coupler part #DM12717 is the bolt pattern which is just slightly different with one having an extra hole.

We can get you a good replacement, though there is actually no longer a TDE brand. But that actuator is simply a bolt-on, 7,500 lb actuator that couples to a 2" hitch ball, and per the owner's manual does not have a lockout (so it is…

The coupler I recommend for your boat trailer is the Demco Channel Tongue Trailer Coupler #12564, which fits a 3" wide channel tongue, has a 10,000 lb capacity and uses the eZ-Latch system to fit a 2" hitch ball. This will allow you…

The HydraStar Vented Marine Electric Over Hydraulic Actuator for Disc Brakes #HS481-8067 that you referenced does include the breakaway kit for sure.

The HydraStar Vented Marine Electric Over Hydraulic Actuator for Disc Brakes part #HS481-8067 has the factory brake controller adapter included so it will work with any integrated factory trailer brake controller like a 2018 Ford F-150 Raptor.

Since your 2014 Ford F-150 has the integrated brake controller the kit you would want is the part #HS481-8067 which comes with the correct adapter for that. That's the big difference between it and the part #HS381-9067 that you also…

I attached a link to an installation video for the #HBA-CAM you can check out. At About the 6:25 mark on the video, the electrical connection is shown. As long as you have a solid connection between the Actuator and the #HBA-CAM, it would work.

Yes, the grease seal part #GS-2125DL that you referenced is the correct seal you'd need for your 5,200 lb UFP Dexter axle. This matches the dimensions you listed.