etrailer Trigger Latch Channel Tongue Trailer Coupler Review Video

The 4-Leaf Slipper Spring w/ Radius End for 2,000-lb Trailer Axles #e69SR should be compressed ~2" under a 1,000 lb load which would make the "F" measurement ~1 3/4" with the 1,000 lb load. This is based on a formula to find…

Since the tongue of your trailer flares out you could just cut a piece of wood to match the angle of the flare to square up the tongue and then clamp-on the etrailer Round/Wheeled Swivel Jack #e79CR. If the trailer stays outside a majority of the…

To choose a compatible hub assembly for any spindle the key is knowing the inner and outer bearing part numbers, or if they are not available, precise dimensions of the spindle at the points where the bearings and grease seal ride. These points on…

You can use springs with a lower capacity than your existing springs to help provide an easier ride for your PWC. The #SP-178275 springs are a great choice. It is important to keep in mind that going with a lower weight rated spring will reduce the…

The bolts for the mounting hardware that comes with the Round Swivel Marine Jack w/ Wheel #MJ-1500B have an overall length of 4 1/4" and the thread is 3/8-16 course threaded. If you are needing new hardware for this jack then we actually have…

I contacted CE Smith to verify the sizing, and the center hole on the #CE20015G is 7/16". They also verified the 4 holes around the edges are indeed 3/8" as well. The 1 3/4" is referring to the diameter of the axle and width of the…

You will want to use a dial caliper or micrometer to measure the inner diameter of the hub you have on your trailer to determine what size cap would be needed. Check out the picture I attached that shows this measurement being taken on a hub. I…

If you are looking for a grease cap PLUG with the TRP stamped on it chances are the Grease Cap Plug for E-Z Lube Grease Caps #RG04-010 would work for you, but to be certain you will want to measure the diameter of the grease cap hole. If it is 1.18…

Yes, we have channel-mount style couplers for 1-7/8 inch hitch balls like the part #CT-2003-Z. This is a bolt-on coupler that fits a 3 inch wide channel.

The distance between the mounting holes on the coupler part #CT-2003-Z is 2-1/4 inches like what your old coupler has so this will be a direct replacement.

I do have an option but Shelby Trailer Products went out of business years ago so replacement parts are just not an option. Therefore, you will need to cut the old coupler off and then bolt-on a new one for which I recommend the Channel Tongue…

You will wire the black and red wires from the 3 wire pig tail to the two wires from your trailer, the red wire will be wired to the turn signal circuit and the black wire will wire to the tail light circuit. The third (white) wire from the pig tail…